Log GPS data on pad after boost detect.
[fw/altos] / src /
2010-02-14 Keith PackardLog GPS data on pad after boost detect.
2010-02-12 Keith PackardMissing ao_mutex_put in gps_dump
2010-01-11 Keith PackardSwitch to using internal cc1111 temperature sensor
2010-01-10 Keith PackardForce idle mode by shorting the SPI clock to ground...
2010-01-10 Keith PackardAdd simple gps dump command 'g'
2010-01-10 Keith PackardRemove flash debugging printfs
2010-01-10 Keith PackardDon't set ao_flash_setup_done until we're actually...
2010-01-10 Keith PackardDump config block from read/write config and flash_stat...
2010-01-10 Keith PackardDump more flash parameters for the flash_status command
2010-01-10 Keith PackardAdd 'f' command to display flash status register contents
2010-01-09 Keith PackardAdd at45db161d.h header file for new flash part.
2010-01-09 Keith PackardRemove green LED and temp sensor from v0.2 code
2010-01-09 Keith PackardAdd AT45DBxx1D driver
2009-12-20 Keith PackardRemove dbg driver code from telemetrum/teledongle
2009-12-19 Keith PackardEnsure that ao_alarm waits at least the specified time
2009-12-19 Keith PackardDisable monitor mode before attempting radio test.
2009-12-19 Keith PackardUse ao_radio_get/ao_radio_put in packet code.
2009-12-16 Keith PackardAdd --cal to man page
2009-12-06 Keith PackardAllow radio calibration to be set from ao-load
2009-12-05 Keith PackardRe-order config values. Change frequency to cal
2009-12-05 Keith PackardAdd radio calibration configuration.
2009-12-05 Keith PackardMake ao_cmd_decimal produce both 32 and 16 bit values.
2009-12-05 Keith PackardRemove send_serial and serial_baud commands.
2009-12-04 Keith PackardChange default callsign to "N0CALL"
2009-11-22 Keith PackardMake TD print 0000-00-00 for invalid dates.
2009-11-22 Keith PackardDecode HDOP data from skytraq GPS
2009-11-20 Keith PackardReduce igniter firing time from 500ms to 50ms.
2009-11-20 Bdale Garbeefix typo in comment
2009-11-16 Keith PackardStop using SiRF state info.
2009-11-16 Keith PackardAdd date to GPS data, captured from GPRMC packet.
2009-11-15 Keith PackardAdd flight number to telemetry stream.
2009-11-15 Keith PackardProvide a dummy 'uninstall' target in the src directory.
2009-11-15 Keith PackardLoosen tolerances for main->landed transition
2009-11-06 Keith PackardReturn radio to telemetry settings when packet system...
2009-11-06 Keith PackardAdd reboot command.
2009-11-06 Keith PackardAdd Watchdog Timer Control register definitions
2009-11-06 Keith PackardMove ao_match_word from ao_ignite.c to ao_cmd.c
2009-11-05 Keith PackardExplicitly use USB I/O routines in packet code
2009-11-05 Keith PackardIn USB pollchar, wait for packet before re-checking...
2009-11-05 Keith PackardIn packet master, move USB flush from packet thread...
2009-11-03 Keith PackardPass accel calibration over telemetry stream. Telemetry...
2009-11-03 Keith Packardao_flight_test was using accel value for pressure too
2009-11-03 Keith PackardReformat ADC values to show all 16 bits
2009-11-03 Keith PackardRemove "f" command
2009-11-03 Keith PackardRemove "d" command
2009-11-03 Keith PackardRemove "l" command as ao-dumplong no longer uses it
2009-11-03 Keith PackardAdd two-point accelerometer calibration.
2009-11-02 Keith PackardMerge remote branch 'origin/master' 0.6
2009-11-02 Keith PackardAdd ao_usb_pollchar to ao.h
2009-11-02 Keith PackardDisable interrupts while removing tasks from task list
2009-11-02 Keith PackardMerge remote branch 'origin/master' into skytraq
2009-11-02 Keith PackardEnable packet-based communcation to command processor
2009-10-31 Keith PackardNo need to wakeup &ao_tick_count now
2009-10-31 Keith PackardPoke master to speed up packet rate when things are...
2009-10-31 Keith PackardUse ao_alarm for ao_delay so it can be easily interrupted
2009-10-31 Keith PackardDo more flushing in packet test code
2009-10-31 Keith PackardAdd RFIM register
2009-10-31 Keith PackardSend SYN packet to set sequence numbers
2009-10-31 Keith PackardUse ao_radio_done to wait for TX to completely finish...
2009-10-31 Keith PackardSwitch packet code from timer thread to ao_alarm
2009-10-31 Keith PackardRemove reason from ao_dma_abort
2009-10-31 Keith PackardAdd ao_alarm
2009-10-31 Keith PackardWait for TX to finish sending data
2009-10-31 Keith PackardAdd radio carrier command
2009-10-30 Keith PackardInitial packet bits. Just testing transmission
2009-10-16 Keith PackardAdd ao_wake_task and ao_exit
2009-10-16 Keith PackardSave some DSEG space by marking cmd functions __reentrant
2009-10-12 Bdale GarbeeMerge branch 'master' of ssh://git.gag.com/scm/git...
2009-10-11 Keith PackardMerge branch 'master' into skytraq
2009-10-11 Keith PackardAdd apogee igniter delay.
2009-10-10 Keith PackardMerge branch 'master' into skytraq
2009-10-10 Keith PackardReport igniter continuity in pad/idle mode via beeper
2009-10-10 Bdale GarbeeMerge branch 'master' of ssh://git.gag.com/scm/git...
2009-10-10 Keith PackardMerge branch 'master' into skytraq
2009-10-10 Keith PackardMerge branch 'master' into skytraq
2009-10-10 Keith PackardSend 0-length IN packet to flush USB after full packet
2009-10-10 Keith PackardMerge branch 'master' into skytraq
2009-10-10 Keith PackardBuild two versions of TM, one for SiRF, one for SkyTraq
2009-10-10 Keith PackardAdd support for the SkyTraq GPS unit
2009-09-04 Keith PackardSet all of the values to reset the radio for telemetry
2009-09-04 Keith PackardMake RDF beacon only run on pad and after landing.
2009-09-04 Keith PackardAdd back the RDF tone generator
2009-09-03 Bdale GarbeeMerge commit 'origin/master'
2009-09-03 Keith PackardRemove bit-banging debug support from TM board builds
2009-09-03 Keith PackardMake the ao_log_record structures 8 bytes again.
2009-09-03 Keith PackardMake eeprom reads and writes across block boundary...
2009-08-22 Keith PackardEnable GPS degraded mode, set 10 sec degraded timeout.
2009-08-19 Bdale GarbeeMerge branch 'master' of ssh://git.gag.com/scm/git... 0.5
2009-08-19 Keith PackardUpdate ao-view to add GPS satellite tracking data
2009-08-19 Keith PackardHandle GPS satellite tracking data
2009-08-19 Bdale Garbeeadd support for building Debian package
2009-07-18 Keith PackardAdd B command to set serial baud rate
2009-07-18 Keith PackardGet rid of spaces after minus sign in climb value
2009-07-18 Keith PackardSwitch to 57600 baud for GPS data
2009-07-18 Keith PackardDrain serial port before changing speed
2009-07-18 Keith PackardReset GPS at boot time
2009-07-18 Keith PackardFix up serial debug output
2009-07-18 Keith PackardAllow the GPS port to run at 4800 baud if desired
2009-07-18 Keith PackardInitialize the GPS serial protocol state
2009-07-18 Keith PackardUse uint8_t for comparisons to avoid int conversions