altos/test: Adjust CRC error rate after FEC fix

[fw/altos] / doc / usage.inc

diff --git a/doc/usage.inc b/doc/usage.inc
index 68d08bad8690a821f8b5649f70d788e187383156..4e40240b4df70c1de78b7b38b9bed2011bf0d87e 100644 (file)
--- a/doc/usage.inc
+++ b/doc/usage.inc
@@ -167,15 +167,15 @@
                 signals, but no record of the flight will be
                 stored in on-board flash.
 
-               ifdef::easymega,telemega[]
+               ifdef::easymega,telemega,easytimer[]
                |Additional Igniters
                |four very short beeps
-               |Continuity indication for the four additional pyro
-                channels on TeleMega and EasyMega. One high tone for
-                no continuity, one low tone for continuity. These are
+               |Continuity indication for the additional pyro
+                channels on TeleMega, EasyMega and EasyTimer. One high tone for
+                no continuity, one low tone for continuity. On TeleMega and EasyMegay, these are
                 produced after the continuity indicators for the two
                 primary igniter channels.
-               endif::easymega,telemega[]
+               endif::easymega,telemega,easytimer[]
 
                |====
 
@@ -249,14 +249,14 @@
                the current state. See below for how to get the flight
                computer to come up in Idle mode at power on.
 
-               ifdef::telemetrum,easymega,telemega[]
+               ifdef::telemetrum,easymega,telemega,easytimer[]
                For flight computers with accelerometers (TeleMetrum,
-               EasyMega and TeleMega), the mode is selected by the
+               EasyMega, TeleMega and EasyTimer), the mode is selected by the
                orientation of the board during the self test
                interval. If the board is pointing upwards as if ready
                to fly, it will enter Flight/Pad mode. Otherwise, it will
                enter Idle mode.
-               endif::telemetrum,easymega,telemega[]
+               endif::telemetrum,easymega,telemega,easytimer[]
 
                ifdef::easymini[]
                For EasyMini, if the USB cable is connected to a
@@ -315,21 +315,22 @@
        === Using a Different Kind of Battery
 
                EasyMini
-               ifdef::telemini[and TeleMini v2 are]
-               ifndef::telemini[is]
+               ifdef::easytimer[and EasyTimer are]
+               ifndef::easytimer[is]
                designed to use either a
                lithium polymer battery or any other battery producing
                between 4 and 12 volts, such as a rectangular 9V
                battery.
 
-               ifdef::telemega,easymega,telemetrum[]
+               ifdef::telemega,easymega,telemetrum,telemini[]
                [WARNING]
+               ifdef::telemini[TeleMini, ]
                TeleMega, EasyMega and TeleMetrum are only designed to
                operate off a single-cell Lithium Polymer battery and
                cannot be used with any other kind. Connecting a
                different kind of battery to any of these will destroy
                the board.
-               endif::telemega,easymega,telemetrum[]
+               endif::telemega,easymega,telemetrum,telemini[]
 
        === Using Packet Link Mode