first cut at turnon scripts for EasyTimer v2

[fw/altos] / doc / telelaunch-operation.inc

diff --git a/doc/telelaunch-operation.inc b/doc/telelaunch-operation.inc
index 4ad50344e308050a80a38754d2f74669ed6851fb..edc6bfc14a3566569509bc88e7eec38cbfeb4cfa 100644 (file)
--- a/doc/telelaunch-operation.inc
+++ b/doc/telelaunch-operation.inc
@@ -6,6 +6,12 @@
        unit, which early customers (before this manual was even written)
        reported were sufficient to successfully use the system.
 
+       [WARNING]
+       The siren used on TeleFire boxes is intended to be heard at a distance
+       outdoors.  We strongly recommend that you do NOT test the system on
+       your kitchen counter when your significant other has a cup of hot
+       coffee in hand nearby!
+
        The remainder of this section assumes the system has already been
        properly configured with callsign, AES key, and bank numbers for each
        TeleFire box.
@@ -55,7 +61,7 @@
                The TeleLCO unit should be placed on a table at the Launch
                Control position.  It can be helpful for the LCO (the human(s)
                too, not just the electronics!) to be provided with some 
-               shade, but the use of transreflexive LCDs for the digit 
+               shade, but the use of reflective LCDs for the digit 
                displays and ultri-bright LEDs make TeleLCO operation 
                reasonable even in direct sunlight.
 
@@ -92,7 +98,7 @@
                Put a rocket on a launch rail / rod, and connect whip clips
                from a pad output on a TeleFire unit to the motor igniter.
                Verify igniter continuity using the LED associated with that
-               output.  Green is good, red is bad.
+               output.  Green is good.
 
                Switch the TeleFire unit from 'Safe' to 'Arm', at which point
                it will start "chirping" to indicate that it is "armed and