-altos (0.6+85+g82fdbfe) unstable; urgency=low
-
- [ Keith Packard ]
- * Disable monitor mode before attempting radio test.
- * Ensure that ao_alarm waits at least the specified time
- * Remove dbg driver code from telemetrum/teledongle
- * Add AT45DBxx1D driver
- * Remove green LED and temp sensor from v0.2 code
- * Add at45db161d.h header file for new flash part.
- * Add 'f' command to display flash status register contents
- * Dump more flash parameters for the flash_status command
- * Dump config block from read/write config and flash_status commands
- * Don't set ao_flash_setup_done until we're actually done.
- * Remove flash debugging printfs
- * Add simple gps dump command 'g'
- * Force idle mode by shorting the SPI clock to ground at boot time.
- * Switch to using internal cc1111 temperature sensor
- * Missing ao_mutex_put in gps_dump
- * Compute daytime using GPS as time base
- * Pull in a bit more data for filtering the start of the boost
- * Log GPS data on pad after boost detect.
- * Change barometer conversion code to shrink conversion table
- * Change altos build process to support per-product compile-time
- changes
- * Update .gitignore files
- * Quiet make output.
- * Add back stack size checking to altos linking phase
- * Must install .map files for ao-load to work
-
- -- Bdale Garbee <bdale@gag.com> Wed, 24 Feb 2010 14:53:01 -0700
-
-altos (0.6+60+g10d1bbc) unstable; urgency=low
-
- [ Keith Packard ]
- * Use ao_radio_get/ao_radio_put in packet code.
-
- -- Bdale Garbee <bdale@gag.com> Sat, 19 Dec 2009 13:53:32 -0700
-
-altos (0.6+58+gbbb152c) unstable; urgency=low
-
- [ Keith Packard ]
- * Re-order config values. Change frequency to cal
- * Allow radio calibration to be set from ao-load
- * Add --cal to man page
-
- -- Bdale Garbee <bdale@gag.com> Sat, 19 Dec 2009 12:05:26 -0700
-
-altos (0.6+53+gcd49847) unstable; urgency=low
-
- [ Keith Packard ]
- * Remove send_serial and serial_baud commands.
- * Make ao_cmd_decimal produce both 32 and 16 bit values.
- * Add radio calibration configuration.
-
- -- Bdale Garbee <bdale@gag.com> Sat, 05 Dec 2009 11:02:49 -0700
-
-altos (0.6+49+g9a1d7dd) unstable; urgency=low
-
- [ Keith Packard ]
- * Change default callsign to "N0CALL"
-
- -- Bdale Garbee <bdale@gag.com> Fri, 04 Dec 2009 21:01:55 -0700
-
-altos (0.6+47+g4053309) unstable; urgency=low
-
- * fix absolute path in debian/dirs, add Suggests for slim-altusmetrum
- * change home URL in control file to be the AltOS page
-
- -- Bdale Garbee <bdale@gag.com> Thu, 26 Nov 2009 11:15:47 -0700
-
-altos (0.6+43+gd6ba07e) unstable; urgency=low
-
- [ Keith Packard ]
- * Decode HDOP data from skytraq GPS
- * Document ao-postflight --gps and --kml options.
- * Make ao-postflight create filenames using input filenames.
- * Make TD print 0000-00-00 for invalid dates.
- * Fix --plot arg handling. Add -all option.
- * Convert telemetry file GPS satellite information in cc_log_read
- * Don't crash if --plot isn't passed on ao-postflight command line
- * ao-postflight: compute barometric alt for each GPS position
- * ao-postflight: don't try to use missing gps sat data
- * Automatically extract flight number for eeprom and telem filenames.
-
- -- Bdale Garbee <bdale@gag.com> Sun, 22 Nov 2009 10:18:26 -0700
-
-altos (0.6+32+g87e6f3e) unstable; urgency=low
-
- [ Bdale Garbee ]
- * fix typo in comment
-
- [ Keith Packard ]
- * Reduce igniter firing time from 500ms to 50ms.
- * Add GPS date/time output to ao-postflight.
- * Eliminate SiRF state values from ao-view.
-
- -- Bdale Garbee <bdale@gag.com> Fri, 20 Nov 2009 13:18:06 -0700
-
-altos (0.6+27+gb0d7e3f) unstable; urgency=low
-
- [ Keith Packard ]
- * Add two-point accelerometer calibration.
- * Remove "l" command as ao-dumplong no longer uses it
- * Remove "d" command
- * Remove "f" command
- * Reformat ADC values to show all 16 bits
- * ao_flight_test was using accel value for pressure too
- * Pass accel calibration over telemetry stream. Telemetry data format
- change.
- * Add ability to dump eeprom data over radio link.
- * In packet master, move USB flush from packet thread to echo thread
- * In USB pollchar, wait for packet before re-checking USB out len
- * Explicitly use USB I/O routines in packet code
- * Flush pending input when switching to remote packet mode
- * Stop recording in ao-dumplog after receiving an invalid block
- * Move ao_match_word from ao_ignite.c to ao_cmd.c
- * Add Watchdog Timer Control register definitions
- * Add reboot command.
- * Return radio to telemetry settings when packet system closed.
- * ao-postflight: fix sloppy gps sat data realloc code (was crashing).
- * Loosen tolerances for main->landed transition
- * Provide a dummy 'uninstall' target in the src directory.
- * Share telemetry parsing code in cc library.
- * Enable telemetry receive in ao_view
- * Switch order of serial/flight in ao-postflight summary
- * Add flight number to telemetry stream.
- * Add date to GPS data, captured from GPRMC packet.
- * Stop using SiRF state info.
-
- -- Bdale Garbee <bdale@gag.com> Fri, 20 Nov 2009 11:43:56 -0700
-
-altos (0.6) unstable; urgency=low
-
- [ Keith Packard ]
- * Add support for the SkyTraq GPS unit
- * Build two versions of TM, one for SiRF, one for SkyTraq
- * Save some DSEG space by marking cmd functions __reentrant
- * Add ao_wake_task and ao_exit
- * Add keyhole-markup generation for ao-postflight.
- * Initial packet bits. Just testing transmission
- * Add radio carrier command
- * Wait for TX to finish sending data
- * Add ao_alarm
- * Remove reason from ao_dma_abort
- * Switch packet code from timer thread to ao_alarm
- * Use ao_radio_done to wait for TX to completely finish with packet
- * Send SYN packet to set sequence numbers
- * Add RFIM register
- * Do more flushing in packet test code
- * Use ao_alarm for ao_delay so it can be easily interrupted
- * Poke master to speed up packet rate when things are busy
- * No need to wakeup &ao_tick_count now
- * Enable packet-based communcation to command processor
- * Add more docs to the README file
- * Disable interrupts while removing tasks from task list
- * Add ao_usb_pollchar to ao.h
-
- -- Bdale Garbee <bdale@gag.com> Mon, 02 Nov 2009 16:53:45 -0700
-
-altos (0.5+90+g127c312) unstable; urgency=low
-
- * de-version the libreadline-dev build dependency
-
- -- Bdale Garbee <bdale@gag.com> Mon, 02 Nov 2009 15:57:29 -0700
-
-altos (0.5+86+g2de548f) unstable; urgency=low
-
- * automate push of updated and tagged master branch during
- debian/rules prebuild
- * flush repetitive junk out of debian/changelog, and update the
- prebuild target
- * add support for tagging git repository on each Debian package build
-
- -- Bdale Garbee <bdale@gag.com> Mon, 12 Oct 2009 16:54:28 -0600
-
-altos (0.5+77+gc57bd7f) unstable; urgency=low
-
- * build for Debian from git
-
- -- Bdale Garbee <bdale@gag.com> Mon, 12 Oct 2009 15:57:19 -0600
-