altos/telelco-v3.0: Configure SPI GPIO pins to 50MHz

Need enough bandwidth to run at 20MHz

Signed-off-by: Keith Packard <keithp@keithp.com>

diff --git a/src/telelco-v3.0/ao_pins.h b/src/telelco-v3.0/ao_pins.h
index 08135542d5b1205040610b9e8297a6ecc512fb44..be253232ca26afa463982cdc582632e6944d4ab3 100644 (file)
--- a/src/telelco-v3.0/ao_pins.h
+++ b/src/telelco-v3.0/ao_pins.h
@@ -75,7 +75,7 @@
 #define HAS_SPI_1              1       /* NHD-C12864LZ LCD Module */
 #define SPI_1_PA5_PA6_PA7      1
 #define SPI_1_PA6_DISABLE      1
-#define SPI_1_MODE_OUTPUT      STM_GPIO_CR_MODE_OUTPUT_10MHZ
+#define SPI_1_MODE_OUTPUT      STM_GPIO_CR_MODE_OUTPUT_50MHZ
 #define SPI_1_PB3_PB4_PB5      0
 #define SPI_1_PE13_PE14_PE15   0