A typo in the symbol used to enable stdin wakeups from serial1 caused
the input to pend until some other wakeup occurred.
This also makes the serial1 hw flow control pin selects in config 2
work right, although those aren't used by any current product
Signed-off-by: Keith Packard <keithp@keithp.com>
if (!ao_fifo_full(ao_serial1_rx_fifo))
ao_fifo_insert(ao_serial1_rx_fifo, U1DBUF);
ao_wakeup(&ao_serial1_rx_fifo);
-#if USE_SERIAL1_STDIN
+#if USE_SERIAL_1_STDIN
ao_wakeup(&ao_stdin_ready);
#endif
}
/* Make the USART pins be controlled by the USART */
P1SEL |= (1 << 6) | (1 << 7);
+#if HAS_SERIAL_1_HW_FLOW
P1SEL |= (1 << 5) | (1 << 4);
+#endif
#endif
/* UART mode with receiver enabled */