signals, but no record of the flight will be
stored in on-board flash.
+ ifdef::easymega,telemega[]
|Additional Igniters
|four very short beeps
|Continuity indication for the four additional pyro
- |channels on TeleMega and EasyMega. One high tone for
- |no continuity, one low tone for continuity. These are
- |produced after the continuity indicators for the two
- |primary igniter channels.
+ channels on TeleMega and EasyMega. One high tone for
+ no continuity, one low tone for continuity. These are
+ produced after the continuity indicators for the two
+ primary igniter channels.
+ endif::easymega,telemega[]
|====
ifdef::radio[disabled, and the radio goes into transmit-only mode.]
ifndef::radio[disabled.]
The only way to get out of this
- mode is to power the flight computer down.
+ mode is to power the flight computer down. See below for how to get the flight
+ computer to come up in Flight/Pad mode at power on.
Idle::
The flight computer is ready to communicate over USB
ifdef::radio[and in packet mode over the radio.]
You can configure
the flight computer, download data or display
- the current state.
+ the current state. See below for how to get the flight
+ computer to come up in Idle mode at power on.
ifdef::telemetrum,easymega,telemega[]
For flight computers with accelerometers (TeleMetrum,