+ <para>
+ In the unlikely event an accel cal that goes badly, it is possible
+ that TeleMetrum may always come up in 'pad mode' and as such not be
+ listening to either the USB or radio interfaces. If that happens,
+ there is a special hook in the firmware to force the board back
+ in to 'idle mode' so you can re-do the cal. To use this hook, you
+ just need to ground the SPI clock pin at power-on. This pin is
+ available as pin 2 on the 8-pin companion connector, and pin 1 is
+ ground. So either carefully install a fine-gauge wire jumper
+ between the two pins closest to the index hole end of the 8-pin
+ connector, or plug in the programming cable to the 8-pin connector
+ and use a small screwdriver or similar to short the two pins closest
+ to the index post on the 4-pin end of the programming cable, and
+ power up the board. It should come up in 'idle mode' (two beeps).
+ </para>