<surname>Towns</surname>
</author>
<copyright>
- <year>2013</year>
+ <year>2014</year>
<holder>Bdale Garbee and Keith Packard</holder>
</copyright>
<legalnotice>
</para>
</legalnotice>
<revhistory>
+ <revision>
+ <revnumber>1.3.1</revnumber>
+ <date>21 January 2014</date>
+ <revremark>
+ Bug fixes for TeleMega and TeleMetrum v2.0 along with a few
+ small UI improvements.
+ </revremark>
+ </revision>
<revision>
<revnumber>1.3</revnumber>
<date>12 November 2013</date>
rocket as it heads towards apogee.
</para>
<para>
- The height, speed and acceleration are shown along with the
- maximum values for each of them. This allows you to quickly
- answer the most commonly asked questions you'll hear during
- flight.
+ The height, speed, acceleration and tilt are shown along
+ with the maximum values for each of them. This allows you to
+ quickly answer the most commonly asked questions you'll hear
+ during flight.
</para>
<para>
The current latitude and longitude reported by the GPS are
<para>
Selecting the 'Fire Igniter' button brings up the usual device
selection dialog. Pick the desired device. This brings up another
- window which shows the current continuity test status for both
- apogee and main charges.
+ window which shows the current continuity test status for all
+ of the pyro channels.
</para>
<para>
Next, select the desired igniter to fire. This will enable the
Then, divide 434.550 MHz by the
measured frequency and multiply by the current radio cal value show
in the 'c s' command. For an unprogrammed board, the default value
- is 1186611. Take the resulting integer and program it using the 'c f'
+ is 1186611 for cc1111 based products and 7119667 for cc1120
+ based products. Take the resulting integer and program it using the 'c f'
command. Testing with the 'C' command again should show a carrier
within a few tens of Hertz of the intended frequency.
As with all 'c' sub-commands, follow this with a 'c w' to write the
- change to the parameter block in the on-board DataFlash chip.
+ change to the configuration memory.
</para>
<para>
Note that the 'reboot' command, which is very useful on the altimeters,
</appendix>
<appendix>
<title>Release Notes</title>
+ <simplesect>
+ <title>Version 1.3.1</title>
+ <xi:include
+ xmlns:xi="http://www.w3.org/2001/XInclude"
+ href="release-notes-1.3.1.xsl"
+ xpointer="xpointer(/article/*)"/>
+ </simplesect>
<simplesect>
<title>Version 1.3</title>
<xi:include