git.gag.com Git - fw/altos/blob - ao-bringup/turnon_telemetrum

   1 #!/bin/sh
   2
   3 if [ -x ../ao-tools/ao-load/ao-load ]; then
   4         AOLOAD=../ao-tools/ao-load/ao-load
   5 elif [ -x /usr/bin/ao-load ]; then
   6         AOLOAD=/usr/bin/ao-load
   7 else
   8         echo "Can't find ao-load!  Aborting."
   9         exit 1
  10 fi
  11
  12 if [ -x ../ao-tools/ao-rawload/ao-rawload ]; then
  13         RAWLOAD=../ao-tools/ao-rawload/ao-rawload
  14 elif [ -x /usr/bin/ao-rawload ]; then
  15         RAWLOAD=/usr/bin/ao-rawload
  16 else
  17         echo "Can't find ao-rawload!  Aborting."
  18         exit 1
  19 fi
  20
  21 echo "TeleMetrum v1.0 Turn-On and Calibration Program"
  22 echo "Copyright 2010 by Bdale Garbee.  Released under GPL v2"
  23 echo
  24 echo "Expectations:"
  25 echo "\tTeleMetrum v1.0 powered from USB"
  26 echo "\t\twith TeleDongle (on /dev/ttyACM0) cabled to debug header"
  27 echo "\t\twith coax from UHF to frequency counter"
  28 echo
  29 echo -n "TeleMetrum serial number: "
  30 read SERIAL
  31
  32 echo $RAWLOAD
  33
  34 $RAWLOAD -r ao_led_blink.ihx
  35 echo "LEDs should be blinking"
  36 sleep 5
  37
  38 $RAWLOAD -r ao_radio_xmit.ihx
  39 echo -n "Generating RF carrier.  Please enter measured frequency: "
  40 read FREQ
  41
  42 CAL_VALUE=`nickle -e "floor(434.55 / $FREQ * 1186611 + 0.5)"`
  43
  44 echo "Programming flash with cal value " $CAL_VALUE
  45 $AOLOAD --cal $CAL_VALUE /usr/share/altos/telemetrum-v1.0.ihx $SERIAL
  46
  47 echo "Serial number "$SERIAL" programmed with RF cal value "$CAL_VALUE
  48 echo "Unplug and replug USB, cu to the board, confirm freq and record power"