update

[web/gag.com] / rockets / airframes / V2-8 / index.mdwn

diff --git a/rockets/airframes/V2-8/index.mdwn b/rockets/airframes/V2-8/index.mdwn
index 3d023f37e9214ddd93e538f04f703770aba2a51c..b703800ebcce8fa346d8c0e00964b49b738393e2 100644 (file)
--- a/rockets/airframes/V2-8/index.mdwn
+++ b/rockets/airframes/V2-8/index.mdwn
@@ -46,6 +46,17 @@ in place by itself but still assuring axial alignment.  The part was designed
 in [FreeCAD](https://www.freecadweb.org/) and cut on Bdale's 
 [Probotix](https://www.probotix.com/) Comet CNC router.
 
+I originally anticipated this would be another "dual deploy from one 
+airframe break" design, which to be honest I've had mixed results using.  But
+once I saw how the longer coupler in the kit was intended to be assembled, I
+changed my mind.  The kit came with a switch band for the coupler that is
+meant to be both ebay and nose coupler, and when I realized there's enough 
+volume inside the nose cone to hold my choice of "laundry", a "traditional" 
+dual deploy setup with two pyro initiated separation events became plan A.
+
+The airframe geometry should easily support a 4-grain 98mm motor, which can
+be a "full M", so this should be a fun airframe to make research motors for!
+
 ## Design / Simulation File
 
 ## Construction Log
@@ -73,6 +84,9 @@ since the 15.03 release.
 Designed and machined replacement aft ring, located the unused 98mm Aeropack
 retainer already on hand.
 
+2021.02.23
+Installed aft ring with 5-minute epoxy.
+
 ## Photos
 
 ## Flight Log