a few more text tweaks

[web/altusmetrum] / EasyMotor / index.mdwn

diff --git a/EasyMotor/index.mdwn b/EasyMotor/index.mdwn
index 3cb7ef95d5262ae3dd1c215dac3cf1a1b6ac8740..e4a4d1204c81392f6e23fc12827f0f002453016b 100644 (file)
--- a/EasyMotor/index.mdwn
+++ b/EasyMotor/index.mdwn
@@ -30,11 +30,13 @@ sensor screwed in.
 
 The first example is a 98mm snap-ring closure, with the 
 sensor and electronics mounted off-center so a 3/8" all-thread could be used
-in the center for motor retention in a minimum-diameter-ish airframe.  The
-mounting bracket for the electronics was bent from a bit of 1/16" aluminum 
-sheet and screwed to the forward closure with two short 4-40 screws into
-tapped and drilled mounting holes.  Note the use of an A23 12v alkaline battery 
-in a holder on the bracket with the 
+in the center for motor retention in a minimum-diameter-ish airframe.  This
+motor had a small gap between the last propellant grain and the forward
+closure, so having the pressure sampling port off-center wasn't a 
+problem.  The mounting bracket for the electronics was bent from a bit of
+1/16" aluminum sheet and screwed to the forward closure with two short 4-40 
+screws into tapped and drilled mounting holes.  Note the use of an A23 12v
+alkaline battery in a holder on the bracket with the 
 EasyMotor prototype.  These batteries are fine for a flight or two, and both
 they and the little holders for them are cheap on Amazon and make installations
 like this fairly easy to put together: