| 2011-09-12 |
Bdale Garbee | fix silk line width on beeper
|
commit | commitdiff | tree |
| 2011-09-12 |
Bdale Garbee | fix mask clearance on GPS chip
|
commit | commitdiff | tree |
| 2011-09-12 |
Bdale Garbee | fix mask clearance on SMA
|
commit | commitdiff | tree |
| 2011-09-12 |
Bdale Garbee | clean up silk
|
commit | commitdiff | tree |
| 2011-09-12 |
Bdale Garbee | add silkscreen content
|
commit | commitdiff | tree |
| 2011-09-12 |
Bdale Garbee | improve via location
|
commit | commitdiff | tree |
| 2011-09-12 |
Bdale Garbee | signal integrity improvements around GPS chip
|
commit | commitdiff | tree |
| 2011-09-12 |
Bdale Garbee | fix potential broken trace
|
commit | commitdiff | tree |
| 2011-09-12 |
Bdale Garbee | lose tiny trace fragment found by DRC
|
commit | commitdiff | tree |
| 2011-09-12 |
Bdale Garbee | cleaning up perceived DRC issues
|
commit | commitdiff | tree |
| 2011-09-12 |
Bdale Garbee | open up gap between gnd_rf and main gnd planes a bit...
|
commit | commitdiff | tree |
| 2011-09-11 |
Bdale Garbee | fix problem I always have with cc1111 vias not having...
|
commit | commitdiff | tree |
| 2011-09-11 |
Bdale Garbee | add attribute to cause DRC to skip the outline layer
|
commit | commitdiff | tree |
| 2011-09-11 |
Bdale Garbee | clean up and thicken power traces
|
commit | commitdiff | tree |
| 2011-09-11 |
Bdale Garbee | route complete
|
commit | commitdiff | tree |
| 2011-09-11 |
Bdale Garbee | down to 4 disconnects
|
commit | commitdiff | tree |
| 2011-09-11 |
Bdale Garbee | snapshot before changing shunt component type
|
commit | commitdiff | tree |
| 2011-09-11 |
Bdale Garbee | lots of layout work at the rink
|
commit | commitdiff | tree |
| 2011-09-10 |
Bdale Garbee | snapshot work done so far at rink before messing with...
|
commit | commitdiff | tree |
| 2011-09-09 |
Bdale Garbee | worked out gnd_rf area around GPS chip and antenna
|
commit | commitdiff | tree |
| 2011-09-08 |
Bdale Garbee | simplify config files, work on GPS antenna footprint
|
commit | commitdiff | tree |
| 2011-09-08 |
Bdale Garbee | notch pcb edge for SMA wall
|
commit | commitdiff | tree |
| 2011-09-08 |
Bdale Garbee | working on layout
|
commit | commitdiff | tree |
| 2011-09-08 |
Bdale Garbee | snapshot pcb changes
|
commit | commitdiff | tree |
| 2011-08-13 |
Bdale Garbee | move the display higher
|
commit | commitdiff | tree |
| 2011-08-13 |
Bdale Garbee | snapshot
|
commit | commitdiff | tree |
| 2011-07-03 |
Bdale Garbee | significant work on cost-reduced version .. still working...
|
commit | commitdiff | tree |
| 2011-06-05 |
Bdale Garbee | push button data sheet
|
commit | commitdiff | tree |
| 2011-06-04 |
Bdale Garbee | significant schematic updates
|
commit | commitdiff | tree |
| 2011-05-05 |
Bdale Garbee | first cut at a substantially cost-reduced schematic...
|
commit | commitdiff | tree |
| 2011-05-05 |
Bdale Garbee | snapshot
|
commit | commitdiff | tree |
| 2010-12-20 |
Bdale Garbee | fix AVR ISP header footprint
|
commit | commitdiff | tree |
| 2010-12-14 |
Bdale Garbee | catch pcb layout up with schematic changes, declare...
|
commit | commitdiff | tree |
| 2010-12-14 |
Bdale Garbee | switch audio amp to use LiPo rail directly for VCC...
|
commit | commitdiff | tree |
| 2010-11-23 |
Bdale Garbee | capture a few more thoughts from turn-on
|
commit | commitdiff | tree |
| 2010-11-18 |
Bdale Garbee | allow value changes from schematic to flow through...
|
commit | commitdiff | tree |
| 2010-11-18 |
Bdale Garbee | update to reflect changed footprint name
|
commit | commitdiff | tree |
| 2010-11-03 |
Bdale Garbee | change in lipo connector footprint name, DK part number...
|
commit | commitdiff | tree |
| 2010-11-02 |
Bdale Garbee | value changes from initial turnon, attributes from...
|
commit | commitdiff | tree |
| 2010-10-31 |
Bdale Garbee | change TS4902 to narrower of the "standard" SOIC footprints
|
commit | commitdiff | tree |
| 2010-10-31 |
Bdale Garbee | data and glabels file for generating parts prep labels...
|
commit | commitdiff | tree |
| 2010-10-23 |
Bdale Garbee | archive zip of data submitted for v0.1 raw board and...
|
commit | commitdiff | tree |
| 2010-10-23 |
Bdale Garbee | another mask clearance issue resolved
|
commit | commitdiff | tree |
| 2010-10-23 |
Bdale Garbee | DJ showed me how to do exports from the pcb command...
|
commit | commitdiff | tree |
| 2010-10-22 |
Bdale Garbee | make sure we're up to date on forward annotations
|
commit | commitdiff | tree |
| 2010-10-22 |
Bdale Garbee | fix AVR footprint name
|
commit | commitdiff | tree |
| 2010-10-22 |
Bdale Garbee | more freedfm-inspired cleanup work
|
commit | commitdiff | tree |
| 2010-10-22 |
Bdale Garbee | more cleanup issues
|
commit | commitdiff | tree |
| 2010-10-22 |
Bdale Garbee | fix more clearance issues
|
commit | commitdiff | tree |
| 2010-10-22 |
Bdale Garbee | post cleanup
|
commit | commitdiff | tree |
| 2010-10-22 |
Bdale Garbee | fix DFM issues identified by freedfm.com .. mostly...
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | make more component attributes invisible on the schematic
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | add the rest of my relevant data sheets to git repo
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | more component attributes
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | flow attribute changes through to pcb file
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | fill in as many attributes as I know without Internet...
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | add two more bypass caps, one near GPS chip, one near...
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | ground plane constrained within board outline at corners...
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | significant improvements in bottom side ground plane...
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | add partially-populated companion connector so we can...
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | lose the LED on the cc1111, and put test points on...
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | move sw_center off pc7 in case we decide that we need...
|
commit | commitdiff | tree |
| 2010-10-21 |
Bdale Garbee | add trace to connect LCD R/W line at Keith's request
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | no disconnects, and no DRC errors
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | fix via annular ring dimension
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | fix element silk minimum dimensions, matching changes...
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | more DRC fixes
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | more DRC fixes
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | moved R4 and R5 over near the regulators
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | fixed a number of DRC issues .. more to go
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | only pin 1 of the ALPS switch footprint should be square
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | cleaning up some traces
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | clean up v_usb trace, etc
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | fully routed .. but not pretty!
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | move audio to pin the beeper used to use on TeleMetrum
|
commit | commitdiff | tree |
| 2010-10-20 |
Bdale Garbee | much more pcb work
|
commit | commitdiff | tree |
| 2010-10-19 |
Bdale Garbee | board size adjusted so SMA fits inside box, USB as...
|
commit | commitdiff | tree |
| 2010-10-19 |
Bdale Garbee | moved parts around .. pcb still over-long .. 4862 is...
|
commit | commitdiff | tree |
| 2010-10-19 |
Bdale Garbee | reduced size of LCD pads, more traces added
|
commit | commitdiff | tree |
| 2010-10-15 |
Bdale Garbee | continuing to work on layout
|
commit | commitdiff | tree |
| 2010-10-14 |
Bdale Garbee | significant progress during EWR->DEN flight
|
commit | commitdiff | tree |
| 2010-10-14 |
Bdale Garbee | clean up outline layer
|
commit | commitdiff | tree |
| 2010-10-14 |
Bdale Garbee | snapshot before bounding plane corners
|
commit | commitdiff | tree |
| 2010-10-14 |
Bdale Garbee | ground plane successfully split
|
commit | commitdiff | tree |
| 2010-10-14 |
Bdale Garbee | snapshot before splitting gnd plane under GPS chip
|
commit | commitdiff | tree |
| 2010-10-07 |
Bdale Garbee | snapshot .. about 100 disconnects left
|
commit | commitdiff | tree |
| 2010-08-27 |
Bdale Garbee | more work on pcb
|
commit | commitdiff | tree |
| 2010-08-27 |
Bdale Garbee | snapshot after some footprint changes
|
commit | commitdiff | tree |
| 2010-08-26 |
Bdale Garbee | update pcb to reflect new switch footprint, etc
|
commit | commitdiff | tree |
| 2010-08-26 |
Bdale Garbee | update footprint for power switch to use C&K DPDT push...
|
commit | commitdiff | tree |
| 2010-08-13 |
Bdale Garbee | replace LCD footprint with one that isn't being integer...
|
commit | commitdiff | tree |
| 2010-08-13 |
Bdale Garbee | add git ignore file, clean up what is and is not in...
|
commit | commitdiff | tree |
| 2010-08-13 |
Bdale Garbee | pondering component placements
|
commit | commitdiff | tree |
| 2010-08-13 |
Bdale Garbee | rotated, all existing trace routing erased
|
commit | commitdiff | tree |
| 2010-08-12 |
Bdale Garbee | board outline complete for Hammond 1559B box
|
commit | commitdiff | tree |
| 2010-08-12 |
Bdale Garbee | snapshot
|
commit | commitdiff | tree |
| 2010-08-12 |
Bdale Garbee | cleaning up attribute visibility in schematic
|
commit | commitdiff | tree |
| 2010-06-25 |
Bdale Garbee | update Makefile to reflect removal of PIC source file
|
commit | commitdiff | tree |
| 2010-06-25 |
Bdale Garbee | clean up a bit
|
commit | commitdiff | tree |
| 2010-06-25 |
Bdale Garbee | getting closer to having the right footprints included
|
commit | commitdiff | tree |
| next |
projects / hw / teleterra / search