If the target supports SYSRESETREQ make sure we use that as the default
if srst is not fitted/configured.
Change-Id: I24c907493134506320e69c1218702930629c1cdc
Signed-off-by: Spencer Oliver <spen@spen-soft.co.uk>
Reviewed-on: http://openocd.zylin.com/792
Tested-by: jenkins
Reviewed-by: Freddie Chopin <freddie.chopin@gmail.com>
$_TARGETNAME configure -event gdb-flash-erase-start {
halt
}
$_TARGETNAME configure -event gdb-flash-erase-start {
halt
}
+
+# if srst is not fitted use SYSRESETREQ to
+# perform a soft reset
+cortex_m3 reset_config sysresetreq
set _FLASHNAME $_CHIPNAME.flash
flash bank flash0 at91sam3 0x00400000 0 0 0 $_TARGETNAME
set _FLASHNAME $_CHIPNAME.flash
flash bank flash0 at91sam3 0x00400000 0 0 0 $_TARGETNAME
+
+# if srst is not fitted use SYSRESETREQ to
+# perform a soft reset
+cortex_m3 reset_config sysresetreq
+
$_TARGETNAME configure -event gdb-flash-erase-start {
halt
}
$_TARGETNAME configure -event gdb-flash-erase-start {
halt
}
+
+# if srst is not fitted use SYSRESETREQ to
+# perform a soft reset
+cortex_m3 reset_config sysresetreq
$_CHIPNAME.cpu configure -event examine-start { puts "START..." ; }
$_CHIPNAME.cpu configure -event examine-end { puts "END..." ; }
$_CHIPNAME.cpu configure -event examine-start { puts "START..." ; }
$_CHIPNAME.cpu configure -event examine-end { puts "END..." ; }
+
+# if srst is not fitted use SYSRESETREQ to
+# perform a soft reset
+cortex_m3 reset_config sysresetreq
$_CHIPNAME.cpu configure -event examine-start { puts "START..." ; }
$_CHIPNAME.cpu configure -event examine-end { puts "END..." ; }
$_CHIPNAME.cpu configure -event examine-start { puts "START..." ; }
$_CHIPNAME.cpu configure -event examine-end { puts "END..." ; }
+
+# if srst is not fitted use SYSRESETREQ to
+# perform a soft reset
+cortex_m3 reset_config sysresetreq
+
+# if srst is not fitted use VECTRESET to
+# perform a soft reset - SYSRESETREQ is not supported
+cortex_m3 reset_config vectreset
target create $_CHIPNAME.m4 cortex_m3 -chain-position $_CHIPNAME.m4
target create $_CHIPNAME.m0 cortex_m3 -chain-position $_CHIPNAME.m0
target create $_CHIPNAME.m4 cortex_m3 -chain-position $_CHIPNAME.m4
target create $_CHIPNAME.m0 cortex_m3 -chain-position $_CHIPNAME.m0
+
+# if srst is not fitted use SYSRESETREQ to
+# perform a soft reset
+cortex_m3 reset_config sysresetreq