Some script have been added or modified after the patches for
reworking the adapter commands were pushed in gerrit.
Such scripts use the old command syntax and trigger a "deprecated"
warning at runtime.
Fix them with the same sed commands used for the other scripts:
sed -i 's/^interface /adapter driver /' $(find tcl/ -type f)
sed -i 's/adapter_khz/adapter speed/g' $(find tcl/ -type f)
sed -i 's/adapter_nsrst_delay/adapter srst delay/g' $(find tcl/ -type f)
sed -i 's/adapter_nsrst_assert_width/adapter srst pulse_width/g' $(find tcl/ -type f)
Change-Id: I0824d6c506a9af3eb9129b74c02a92b4eb1b100d
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
Reviewed-on: http://openocd.zylin.com/5424
Reviewed-by: Oleksij Rempel <linux@rempel-privat.de>
Tested-by: jenkins
source [find interface/jlink.cfg]
transport select swd
-adapter_khz 1000
+adapter speed 1000
source [find target/nrf52.cfg]
# Old ST-LINK/V1 and ST-LINK/V2 pre version V2J24 don't support this method
#
-interface st-link
+adapter driver st-link
st-link vid_pid 0x0483 0x3748 0x0483 0x374b 0x0483 0x374d 0x0483 0x374e 0x0483 0x374f 0x0483 0x3752 0x0483 0x3753
# transport select dapdirect_jtag
cortex_m reset_config sysresetreq
}
-adapter_khz 1000
+adapter speed 1000
#
# Note that there is a pretty wide band where things are
# more or less stable, see http://openocd.zylin.com/#/c/3366/
-adapter_khz 500
+adapter speed 500
-adapter_nsrst_delay 100
+adapter srst delay 100
if {[using_jtag]} {
jtag_ntrst_delay 100
}
mmw 0x58004000 0x00000102 0 ;# FLASH_ACR |= PRFTBE | 2(Latency)
mmw 0x58000000 0x00000091 0 ;# RCC_CR = MSI_ON | MSI Range 24 MHz
# Boost JTAG frequency
- adapter_khz 4000
+ adapter speed 4000
}
$_TARGETNAME configure -event reset-start {
# Reset clock is MSI (4 MHz)
- adapter_khz 500
+ adapter speed 500
}
$_TARGETNAME configure -event examine-end {
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME swm050 0x0 0x2000 0 0 $_TARGETNAME
-adapter_khz 1000
+adapter speed 1000
$_TARGETNAME configure -event reset-init {
# Stop the watchdog, just to be safe