/* ao_spi_stm.c
*/
-#define AO_SPI_SPEED_FAST STM_SPI_CR1_BR_PCLK_4
+/* PCLK is set to 16MHz (HCLK 32MHz, APB prescaler 2) */
+
+#define AO_SPI_SPEED_8MHz STM_SPI_CR1_BR_PCLK_2
+#define AO_SPI_SPEED_4MHz STM_SPI_CR1_BR_PCLK_4
+#define AO_SPI_SPEED_2MHz STM_SPI_CR1_BR_PCLK_8
#define AO_SPI_SPEED_1MHz STM_SPI_CR1_BR_PCLK_16
-#define AO_SPI_SPEED_200kHz STM_SPI_CR1_BR_PCLK_256
+#define AO_SPI_SPEED_500kHz STM_SPI_CR1_BR_PCLK_32
+#define AO_SPI_SPEED_250kHz STM_SPI_CR1_BR_PCLK_64
+#define AO_SPI_SPEED_125kHz STM_SPI_CR1_BR_PCLK_128
+#define AO_SPI_SPEED_62500Hz STM_SPI_CR1_BR_PCLK_256
+
+#define AO_SPI_SPEED_FAST AO_SPI_SPEED_8MHz
+
+/* Companion bus wants something no faster than 200kHz */
+
+#define AO_SPI_SPEED_200kHz AO_SPI_SPEED_125kHz
#define AO_SPI_CONFIG_1 0x00
#define AO_SPI_1_CONFIG_PA5_PA6_PA7 AO_SPI_CONFIG_1
stm_rcc.ahbenr |= (1 << STM_RCC_AHBENR_GPIOEEN); \
} while (0)
+#define ao_disable_port(port) do { \
+ if ((port) == &stm_gpioa) \
+ stm_rcc.ahbenr &= ~(1 << STM_RCC_AHBENR_GPIOAEN); \
+ else if ((port) == &stm_gpiob) \
+ stm_rcc.ahbenr &= ~(1 << STM_RCC_AHBENR_GPIOBEN); \
+ else if ((port) == &stm_gpioc) \
+ stm_rcc.ahbenr &= ~(1 << STM_RCC_AHBENR_GPIOCEN); \
+ else if ((port) == &stm_gpiod) \
+ stm_rcc.ahbenr &= ~(1 << STM_RCC_AHBENR_GPIODEN); \
+ else if ((port) == &stm_gpioe) \
+ stm_rcc.ahbenr &= ~(1 << STM_RCC_AHBENR_GPIOEEN); \
+ } while (0)
+
#define ao_gpio_set(port, bit, pin, v) stm_gpio_set(port, bit, v)
stm_moder_set(port, bit, STM_MODER_OUTPUT);\
} while (0)
-#define ao_enable_input(port,bit,mode) do { \
- ao_enable_port(port); \
- stm_moder_set(port, bit, STM_MODER_INPUT); \
+#define ao_gpio_set_mode(port,bit,mode) do { \
if (mode == AO_EXTI_MODE_PULL_UP) \
stm_pupdr_set(port, bit, STM_PUPDR_PULL_UP); \
else if (mode == AO_EXTI_MODE_PULL_DOWN) \
else \
stm_pupdr_set(port, bit, STM_PUPDR_NONE); \
} while (0)
+
+#define ao_enable_input(port,bit,mode) do { \
+ ao_enable_port(port); \
+ stm_moder_set(port, bit, STM_MODER_INPUT); \
+ ao_gpio_set_mode(port, bit, mode); \
+ } while (0)
#define ao_enable_cs(port,bit) do { \
stm_gpio_set((port), bit, 1); \
void
ao_i2c_init(void);
+/* ao_serial_stm.c */
+struct ao_stm_usart {
+ struct ao_fifo rx_fifo;
+ struct ao_fifo tx_fifo;
+ struct stm_usart *reg;
+ uint8_t tx_started;
+};
+
+#if HAS_SERIAL_1
+extern struct ao_stm_usart ao_stm_usart1;
+#endif
+
+#if HAS_SERIAL_2
+extern struct ao_stm_usart ao_stm_usart2;
+#endif
+
+#if HAS_SERIAL_3
+extern struct ao_stm_usart ao_stm_usart3;
+#endif
+
+#define ARM_PUSH32(stack, val) (*(--(stack)) = (val))
+
+static inline uint32_t
+ao_arch_irqsave(void) {
+ uint32_t primask;
+ asm("mrs %0,primask" : "=&r" (primask));
+ ao_arch_block_interrupts();
+ return primask;
+}
+
+static inline void
+ao_arch_irqrestore(uint32_t primask) {
+ asm("msr primask,%0" : : "r" (primask));
+}
+
+static inline void
+ao_arch_memory_barrier() {
+ asm volatile("" ::: "memory");
+}
+
+#if HAS_TASK
+static inline void
+ao_arch_init_stack(struct ao_task *task, void *start)
+{
+ uint32_t *sp = (uint32_t *) (task->stack + AO_STACK_SIZE);
+ uint32_t a = (uint32_t) start;
+ int i;
+
+ /* Return address (goes into LR) */
+ ARM_PUSH32(sp, a);
+
+ /* Clear register values r0-r12 */
+ i = 13;
+ while (i--)
+ ARM_PUSH32(sp, 0);
+
+ /* APSR */
+ ARM_PUSH32(sp, 0);
+
+ /* PRIMASK with interrupts enabled */
+ ARM_PUSH32(sp, 0);
+
+ task->sp = sp;
+}
+
+static inline void ao_arch_save_regs(void) {
+ /* Save general registers */
+ asm("push {r0-r12,lr}\n");
+
+ /* Save APSR */
+ asm("mrs r0,apsr");
+ asm("push {r0}");
+
+ /* Save PRIMASK */
+ asm("mrs r0,primask");
+ asm("push {r0}");
+}
+
+static inline void ao_arch_save_stack(void) {
+ uint32_t *sp;
+ asm("mov %0,sp" : "=&r" (sp) );
+ ao_cur_task->sp = (sp);
+ if ((uint8_t *) sp < &ao_cur_task->stack[0])
+ ao_panic (AO_PANIC_STACK);
+}
+
+static inline void ao_arch_restore_stack(void) {
+ uint32_t sp;
+ sp = (uint32_t) ao_cur_task->sp;
+
+ /* Switch stacks */
+ asm("mov sp, %0" : : "r" (sp) );
+
+ /* Restore PRIMASK */
+ asm("pop {r0}");
+ asm("msr primask,r0");
+
+ /* Restore APSR */
+ asm("pop {r0}");
+ asm("msr apsr,r0");
+
+ /* Restore general registers */
+ asm("pop {r0-r12,lr}\n");
+
+ /* Return to calling function */
+ asm("bx lr");
+}
+
+#define HAS_ARCH_START_SCHEDULER 1
+
+static inline void ao_arch_start_scheduler(void) {
+ uint32_t sp;
+ uint32_t control;
+
+ asm("mrs %0,msp" : "=&r" (sp));
+ asm("msr psp,%0" : : "r" (sp));
+ asm("mrs %0,control" : "=&r" (control));
+ control |= (1 << 1);
+ asm("msr control,%0" : : "r" (control));
+}
+
+#define ao_arch_isr_stack()
+
+#endif
+
+#define ao_arch_wait_interrupt() do { \
+ asm(".global ao_idle_loc\n\twfi\nao_idle_loc:"); \
+ ao_arch_release_interrupts(); \
+ ao_arch_block_interrupts(); \
+ } while (0)
+
+#define ao_arch_critical(b) do { \
+ ao_arch_block_interrupts(); \
+ do { b } while (0); \
+ ao_arch_release_interrupts(); \
+ } while (0)
+
#endif /* _AO_ARCH_FUNCS_H_ */
projects / fw / altos / blobdiff