update info on using separate pyro batteries to encourage including a switch

[fw/altos] / doc / telemega.inc

diff --git a/doc/telemega.inc b/doc/telemega.inc
index 55f77bc48771d6db476df1adb85c4325cdd0378e..092077e00da73e04923c77167f9e783d965e8283 100644 (file)
--- a/doc/telemega.inc
+++ b/doc/telemega.inc
@@ -1,7 +1,7 @@
 == TeleMega
 
        .TeleMega Board
-       image::telemega-v1.0-top.jpg[width="5.5in"]
+       image::telemega-v1.0-top.jpg[width=400]
 
        TeleMega is a 1¼ inch by 3¼ inch circuit board. It was
        designed to easily fit in a 38mm coupler. Like TeleMetrum,
@@ -109,9 +109,12 @@
                TeleMega provides explicit support for an external pyro
                battery. All that is required is to remove the jumper
                between the lipo terminal (Bottom 3) and the pyro terminal
-               (Bottom 2). Then hook the negative pyro battery terminal to ground
-               (Bottom 1) and the positive pyro battery to the pyro battery
-               input (Bottom 2). You can then use the existing pyro screw
+               (Bottom 2). Then hook the negative pyro battery terminal to 
+               ground (Bottom 1) and the switched positive pyro battery to 
+               the pyro battery input (Bottom 2). Note that you must include
+                a switch between the pyro battery and the board for safety,
+                as the on-board power switch circuit only supports the primary
+                battery!  You can then use the existing pyro screw
                terminals to hook up all of the pyro charges.
 
        === Using Only One Battery With TeleMega