Replace 'see chapter "foo"' with 'see <<foo>>' so that a link is
created to directly go to the relevant text.
Signed-off-by: Keith Packard <keithp@keithp.com>
data will be downloaded from that device directly. If
you select a TeleDongle device, flight data will be
downloaded from a flight computer over radio link via
data will be downloaded from that device directly. If
you select a TeleDongle device, flight data will be
downloaded from a flight computer over radio link via
- the specified TeleDongle. See the chapter on
- Controlling An Altimeter Over The Radio Link for more
- information.
+ the specified TeleDongle. See
+ <<_controlling_an_altimeter_over_the_radio_link>> for
+ more information.
After the device has been selected, a dialog showing
the flight data saved in the device will be shown
After the device has been selected, a dialog showing
the flight data saved in the device will be shown
Once a flight record is selected, the flight monitor interface
is displayed and the flight is re-enacted in real time. Check
Once a flight record is selected, the flight monitor interface
is displayed and the flight is re-enacted in real time. Check
- the Monitor Flight chapter above to learn how this window operates.
+ <<_monitor_flight>> to learn how this window operates.
programming). TeleMega, EasyMega, TeleMetrum v2,
EasyMini and TeleDongle v3 are all programmed directly
over their USB ports (self programming). Please read
programming). TeleMega, EasyMega, TeleMetrum v2,
EasyMini and TeleDongle v3 are all programmed directly
over their USB ports (self programming). Please read
- the directions for flashing devices in the Updating
- Device Firmware chapter below.
+ the directions for flashing devices in
+ <<_updating_device_firmware>>.
interval of at least 5 seconds to avoid consuming too much
battery power or radio channel bandwidth. You can configure
the APRS interval using {application}; that process is described in
interval of at least 5 seconds to avoid consuming too much
battery power or radio channel bandwidth. You can configure
the APRS interval using {application}; that process is described in
- <<{configure_section}>> in the {application} chapter.
+ <<{configure_section}>>.
AltOS supports both compressed and uncompressed APRS
position report data formats. The compressed format
AltOS supports both compressed and uncompressed APRS
position report data formats. The compressed format
The rest of the dialog contains the parameters to be configured.
The rest of the dialog contains the parameters to be configured.
- The rest of the dialog contains the parameters to be configured.
-
include::config-device.raw[]
=== Flash Device
This reprograms TeleGPS devices with new
firmware. Please read the directions for flashing
include::config-device.raw[]
=== Flash Device
This reprograms TeleGPS devices with new
firmware. Please read the directions for flashing
- devices in the Updating Device Firmware chapter below.
+ devices in <<_updating_device_firmware>>.
=== Configurable Parameters
=== Configurable Parameters
- Configuring TeleGPS is very
- simple; the few configurable parameters can all be set
- using the TeleGPS application over USB. Read
- the Configure TeleGPS section in the TeleGPS Software chapter
+ Configuring TeleGPS is very simple; the few configurable
+ parameters can all be set using the TeleGPS application over
+ USB. Check out <<_configure_device>>.