#define HAS_TASK_QUEUE 0
-#define AO_HSE 8000000
+/* Bridge SB17 on the board and use the MCO from the other chip */
+#define AO_HSE 8000000
+#define AO_HSE_BYPASS 1
/* PLLVCO = 96MHz (so that USB will work) */
#define AO_PLLMUL 12
#define PACKET_HAS_SLAVE 0
#define LED_PORT_ENABLE STM_RCC_AHBENR_GPIOCEN
-#define LED_PORT (&stm_gpioc)
-#define LED_PIN_RED 8
-#define LED_PIN_GREEN 9
+#define LED_PORT (&stm_gpiob)
+#define LED_PIN_RED 6
+#define LED_PIN_GREEN 7
#define AO_LED_RED (1 << LED_PIN_RED)
#define AO_LED_GREEN (1 << LED_PIN_GREEN)
#define AO_TICK_SIGNED int32_t
#define HAS_TASK_INFO 0
+#define HAS_VERSION 0
-#define AO_BOOT_APPLICATION_GPIO stm_gpiob
-#define AO_BOOT_APPLICATION_PIN 5
-#define AO_BOOT_APPLICATION_VALUE 0
-#define AO_BOOT_APPLICATION_MODE AO_EXTI_MODE_PULL_UP
-#define AO_BOOT_APPLICATION_BASE 0x2000
+#define AO_BOOT_CHAIN 1
+#define AO_BOOT_PIN 1
+
+#define AO_BOOT_APPLICATION_GPIO stm_gpioa
+#define AO_BOOT_APPLICATION_PIN 0
+#define AO_BOOT_APPLICATION_VALUE 1
+#define AO_BOOT_APPLICATION_MODE 0
+#define AO_BOOT_APPLICATION_BASE ((uint32_t *) 0x2000)
#endif /* _AO_PINS_H_ */