volatile __xdata struct ao_fifo ao_usart1_rx_fifo;
volatile __xdata struct ao_fifo ao_usart1_tx_fifo;
-#if USE_SERIAL_STDIN
-__pdata uint8_t ao_serial_stdin;
-#endif
-
void
ao_serial_rx1_isr(void) __interrupt 3
{
ao_fifo_insert(ao_usart1_rx_fifo, U1DBUF);
ao_wakeup(&ao_usart1_rx_fifo);
#if USE_SERIAL_STDIN
- if (ao_serial_stdin)
- ao_wakeup(&ao_stdin_ready);
+ ao_wakeup(&ao_stdin_ready);
#endif
}
ao_serial_pollchar(void) __critical
{
char c;
-#if 0
- if (!ao_serial_stdin)
- return AO_READ_AGAIN;
-#endif
if (ao_fifo_empty(ao_usart1_rx_fifo))
return AO_READ_AGAIN;
ao_fifo_remove(ao_usart1_rx_fifo,c);
return c;
}
-
-void
-ao_serial_set_stdin(uint8_t stdin)
-{
- ao_serial_stdin = stdin;
-}
-
#endif
void
ao_serial_drain();
if (speed > AO_SERIAL_SPEED_57600)
return;
+ U1UCR |= UxUCR_FLUSH;
U1BAUD = ao_serial_speeds[speed].baud;
U1GCR = ao_serial_speeds[speed].gcr;
}
/* Set up the USART pin assignment */
PERCFG = (PERCFG & ~PERCFG_U1CFG_ALT_MASK) | PERCFG_U1CFG_ALT_2;
- /* ee has already set the P2SEL bits */
+ P2SEL = (P2SEL & ~(P2SEL_PRI3P1_MASK | P2SEL_PRI2P1_MASK)) |
+ (P2SEL_PRI3P1_USART1 | P2SEL_PRI2P1_USART1);
/* Make the USART pins be controlled by the USART */
P1SEL |= (1 << 6) | (1 << 7);
/* Reasonable serial parameters */
U1UCR = (UxUCR_FLUSH |
UxUCR_FLOW_DISABLE |
- UxUCR_D9_ODD_PARITY |
+ UxUCR_D9_EVEN_PARITY |
UxUCR_BIT9_8_BITS |
UxUCR_PARITY_DISABLE |
UxUCR_SPB_1_STOP_BIT |
IEN0 |= IEN0_URX1IE;
IEN2 |= IEN2_UTX1IE;
-#if 0
-#if USE_SERIAL_STDIN
- ao_add_stdio(ao_serial_pollchar,
- ao_serial_putchar,
- NULL);
-#endif
-#endif
}