#define AO_PANIC_REBOOT 8 /* Reboot failed */
#define AO_PANIC_FLASH 9 /* Invalid flash part (or wrong blocksize) */
#define AO_PANIC_USB 10 /* Trying to send USB packet while busy */
+#define AO_PANIC_BT 11 /* Communications with bluetooth device failed */
/* Stop the operating system, beeping and blinking the reason */
void
void
ao_cmd_init(void);
+#if HAS_CMD_FILTER
+/*
+ * Provided by an external module to filter raw command lines
+ */
+uint8_t
+ao_cmd_filter(void);
+#endif
+
/*
* ao_dma.c
*/
#endif
#if HAS_SERIAL_1
+#ifndef USE_SERIAL_STDIN
+#error Please define USE_SERIAL_STDIN
+#endif
+
void
ao_serial_rx1_isr(void) __interrupt 3;
char
ao_serial_getchar(void) __critical;
+#if USE_SERIAL_STDIN
+char
+ao_serial_pollchar(void) __critical;
+
+void
+ao_serial_set_stdin(uint8_t stdin);
+#endif
+
void
ao_serial_putchar(char c) __critical;
+void
+ao_serial_drain(void) __critical;
+
#define AO_SERIAL_SPEED_4800 0
#define AO_SERIAL_SPEED_9600 1
-#define AO_SERIAL_SPEED_57600 2
+#define AO_SERIAL_SPEED_19200 2
+#define AO_SERIAL_SPEED_57600 3
void
ao_serial_set_speed(uint8_t speed);
char (*pollchar)(void);
void (*putchar)(char c) __reentrant;
void (*flush)(void);
+ uint8_t echo;
};
+extern __xdata struct ao_stdio ao_stdios[];
+extern __data int8_t ao_cur_stdio;
+extern __data int8_t ao_num_stdios;
+
void
flush(void);
extern __xdata uint8_t ao_stdin_ready;
-void
+uint8_t
+ao_echo(void);
+
+int8_t
ao_add_stdio(char (*pollchar)(void),
void (*putchar)(char) __reentrant,
void (*flush)(void)) __reentrant;
*/
#define AO_CONFIG_MAJOR 1
-#define AO_CONFIG_MINOR 4
+#define AO_CONFIG_MINOR 5
struct ao_config {
uint8_t major;
int16_t accel_minus_g; /* minor version 2 */
uint32_t radio_cal; /* minor version 3 */
uint32_t flight_log_max; /* minor version 4 */
+ uint8_t ignite_mode; /* minor version 5 */
};
+#define AO_IGNITE_MODE_DUAL 0
+#define AO_IGNITE_MODE_APOGEE 1
+#define AO_IGNITE_MODE_MAIN 2
+
extern __xdata struct ao_config ao_config;
#define AO_CONFIG_MAX_SIZE 128
void
ao_packet_slave_init(uint8_t enable);
+/* ao_btm.c */
+
+/* If bt_link is on P2, this interrupt is shared by USB, so the USB
+ * code calls this function. Otherwise, it's a regular ISR.
+ */
+
+void
+ao_btm_isr(void)
+#if BT_LINK_ON_P1
+ __interrupt 15
+#endif
+ ;
+
+
+void
+ao_btm_init(void);
+
#endif /* _AO_H_ */