This formula is completely fluid with 225F indicated on the Presto Multicooker,
but viscosity is noticeabley lower making for easier pouring at 250-275F.
-These grains were cast on <date>.
+Grain fill lines 120.6mm from the bottom of the casting tube.
+
+These grains were cast on 2018-07-05.
## Results ##
-Average casting tube weight <mumble>g.
+Had to cut about 11mm length off one grain to make things fit, chose to do
+this to the grain with rough core.
-* Grain 1, g gross, g net
-* Grain 2, g gross, g net
-* Grain 3, g gross, g net
-* Grain 4, g gross, g net
-* Grain 5, g gross, g net
-* Grain 6, g gross, g net
-* Grain 7, g gross, g net
+* Grain 1, 670g gross, 17.63g casting tube, g net propellant
+* Grain 2, 668g gross, 17.55g casting tube, g net propellant
+* Grain 3, 674g gross, 17.72g casting tube, g net propellant
+* Grain 4, 672g gross, 17.76g casting tube, g net propellant *** pre trim ***
+* Grain 4, 610g gross, 17.76g casting tube, g net propellant
+* Grain 5, 664g gross, 17.70g casting tube, g net propellant
+* Grain 6, 666g gross, 17.61g casting tube, g net propellant
+* Grain 7, 668g gross, 17.64g casting tube, g net propellant
+Average casting tube weight <mumble>g.
Total propellant load <mumble>g.
Revised simulation says this will be...