altitude with Compressed format. Test before
you fly to see which to use.
+ ==== APRS Offset
+
+ The delay from the top of the minute before sending
+ the first APRS packet of the minute. Coordinating
+ values for this parameter between multiple devices can
+ allow a single receiver to reliably receive APRS
+ packets from multiple devices. Note that this offset only
+ takes effect while the GPS signal is locked so that the
+ transmitting device knows the current time.
+
==== Callsign
This sets the call sign included in each
is fired first, followed after a two second
delay by the 'main' channel.
- ifdef::telemetrum,telemega,easymega[]
+ Separation & Apogee::
+ This fires the 'main' channel when the first motor
+ burns out and fires the 'apogee' charge at apogee.
+
+ ifdef::telemetrum,telemega,easymega,easytimer[]
==== Pad Orientation
Because they include accelerometers,
with the antenna pointing aft instead.
Antenna Up::
- In this mode, the antenna end of the flight
- computer must point forward, in line with the
- expected flight path.
+ In this mode, the antenna (or beeper, for devices
+ without an antenna) of the flight computer must point
+ forward, in line with the expected flight path.
Antenna Down::
- In this mode, the antenna end of the flight
- computer must point aft, in line with the
- expected flight path.
- endif::telemetrum,telemega,easymega[]
+
+ In this mode, the antenna (or beeper, for devices
+ without an antenna) end of the flight computer must
+ point aft, in line with the expected flight path.
+ endif::telemetrum,telemega,easymega,easytimer[]
==== Beeper Frequency
in the log.
endif::telegps[]
-ifdef::telemega,easymega,telemetrum[]
+ifdef::telemega,easymega,easytimer,telemetrum[]
==== Calibrate Accelerometer
Configure Altimeter window and save the new
calibration values.
-endif::telemega,easymega,telemetrum[]
+endif::telemega,easymega,easytimer,telemetrum[]
-ifdef::telemega,easymega[]
+ifdef::telemega,easymega,easytimer[]
==== Configure Pyro Channels
image::configure-pyro.png[width=400]
This opens a separate window to configure the
- additional pyro channels available on TeleMega
- and EasyMega. One column is presented for
+ additional pyro channels available on TeleMega,
+ EasyMega and EasyTimer. One column is presented for
each channel. Each row represents a single
parameter, if enabled the parameter must meet
the specified test for the pyro channel to be
include::pyro-channels.adoc[]
-endif::telemega,easymega[]
+endif::telemega,easymega,easytimer[]