+++ /dev/null
-#!/bin/sh
-
-if [ -x ../ao-tools/ao-load/ao-load ]; then
- AOLOAD=../ao-tools/ao-load/ao-load
-elif [ -x /usr/bin/ao-load ]; then
- AOLOAD=/usr/bin/ao-load
-else
- echo "Can't find ao-load! Aborting."
- exit 1
-fi
-
-if [ -x ../ao-tools/ao-rawload/ao-rawload ]; then
- RAWLOAD=../ao-tools/ao-rawload/ao-rawload
-elif [ -x /usr/bin/ao-rawload ]; then
- RAWLOAD=/usr/bin/ao-rawload
-else
- echo "Can't find ao-rawload! Aborting."
- exit 1
-fi
-
-echo "TeleBT v1.1 Turn-On and Calibration Program"
-echo "Copyright 2013 by Bdale Garbee. Released under GPL v2"
-echo
-echo "Expectations:"
-echo "\tTeleBT v1.1 powered from USB"
-echo "\t\twith TeleDonlge (on /dev/ttyACM0) cabled to debug header"
-echo "\t\twith coax from SMA to frequency counter"
-echo
-echo -n "TeleBT serial number: "
-read SERIAL
-
-echo $RAWLOAD
-
-case $USER in
- bdale)
- DONGLE=100
- ;;
- keithp)
- DONGLE=186
- ;;
- *)
- echo "Unknow user"
- exit 1
- ;;
-esac
-
-$RAWLOAD -D $DONGLE -r ao_led_blink.ihx
-echo "LEDs should be blinking"
-sleep 5
-
-$RAWLOAD -D $DONGLE -r ao_radio_xmit.ihx
-echo -n "Generating RF carrier. Please enter measured frequency: "
-read FREQ
-
-CAL_VALUE=`nickle -e "floor(434.55 / $FREQ * 1186611 + 0.5)"`
-
-echo "Programming flash with cal value " $CAL_VALUE
-$AOLOAD -D $DONGLE --cal $CAL_VALUE ~/altusmetrumllc/Binaries/telebt-v1.0*.ihx $SERIAL
-
-echo "Serial number "$SERIAL" programmed with RF cal value "$CAL_VALUE
-echo $SERIAL","$CAL_VALUE >> cal_values
-echo "Unplug debug cable, power cycle, cu to the board, confirm freq and record power"