fix think-o

[web/altusmetrum] / EasyMotor / index.mdwn

diff --git a/EasyMotor/index.mdwn b/EasyMotor/index.mdwn
index 87c8f6228f2ba60a82020dfa283493913f544519..0a6746b6233b318e53e6409ba4349562f3b89b29 100644 (file)
--- a/EasyMotor/index.mdwn
+++ b/EasyMotor/index.mdwn
@@ -20,13 +20,15 @@ memory chip, the contents of which can be downloaded after flight over USB.
 ## Example Installations ##
 
 There are lots of ways to mount an EasyMotor board, but since we've been
-asked, here are a few photos are from snap-ring case forward closures 
+asked, here are a few photos from snap-ring case forward closures 
 machined by Bdale for
 test flights of EasyMotor.  The sensor bodies are 316 stainless with a 1/8 NPT
 male boss, so the approach chosen is to drill a 1/8 inch touch hole all the
 way through the closure, then drill and tap 1/8 NPT female threads part way
 through the closure thickness.  The hole gets filled with grease and the 
-sensor screwed in.  The first example is a 98mm snap-ring clossure, with the 
+sensor screwed in.  
+
+The first example is a 98mm snap-ring clossure, with the 
 sensor and electronics mounted off-center so a 3/8" all-thread could be used
 in the center for motor retention in a minimum-diameter-ish airframe.  The
 mounting bracket for the electronics was bent from a bit of 1/16" aluminum