unit, which early customers (before this manual was even written)
reported were sufficient to successfully use the system.
unit, which early customers (before this manual was even written)
reported were sufficient to successfully use the system.
The remainder of this section assumes the system has already been
properly configured with callsign, AES key, and bank numbers for each
TeleFire box.
The remainder of this section assumes the system has already been
properly configured with callsign, AES key, and bank numbers for each
TeleFire box.
The TeleLCO unit should be placed on a table at the Launch
Control position. It can be helpful for the LCO (the human(s)
too, not just the electronics!) to be provided with some
The TeleLCO unit should be placed on a table at the Launch
Control position. It can be helpful for the LCO (the human(s)
too, not just the electronics!) to be provided with some
Put a rocket on a launch rail / rod, and connect whip clips
from a pad output on a TeleFire unit to the motor igniter.
Verify igniter continuity using the LED associated with that
Put a rocket on a launch rail / rod, and connect whip clips
from a pad output on a TeleFire unit to the motor igniter.
Verify igniter continuity using the LED associated with that
Switch the TeleFire unit from 'Safe' to 'Arm', at which point
it will start "chirping" to indicate that it is "armed and
Switch the TeleFire unit from 'Safe' to 'Arm', at which point
it will start "chirping" to indicate that it is "armed and