doc: add some text to TeleLaunch troubleshooting about SAFE/ARM on TeleFire
[fw/altos] / doc / telelaunch-operation.inc
index 4ad50344e308050a80a38754d2f74669ed6851fb..db71d91869bc6c1360355663b8d3b657b5709944 100644 (file)
@@ -55,7 +55,7 @@
                The TeleLCO unit should be placed on a table at the Launch
                Control position.  It can be helpful for the LCO (the human(s)
                too, not just the electronics!) to be provided with some 
                The TeleLCO unit should be placed on a table at the Launch
                Control position.  It can be helpful for the LCO (the human(s)
                too, not just the electronics!) to be provided with some 
-               shade, but the use of transreflexive LCDs for the digit 
+               shade, but the use of reflective LCDs for the digit 
                displays and ultri-bright LEDs make TeleLCO operation 
                reasonable even in direct sunlight.
 
                displays and ultri-bright LEDs make TeleLCO operation 
                reasonable even in direct sunlight.
 
@@ -92,7 +92,7 @@
                Put a rocket on a launch rail / rod, and connect whip clips
                from a pad output on a TeleFire unit to the motor igniter.
                Verify igniter continuity using the LED associated with that
                Put a rocket on a launch rail / rod, and connect whip clips
                from a pad output on a TeleFire unit to the motor igniter.
                Verify igniter continuity using the LED associated with that
-               output.  Green is good, red is bad.
+               output.  Green is good.
 
                Switch the TeleFire unit from 'Safe' to 'Arm', at which point
                it will start "chirping" to indicate that it is "armed and 
 
                Switch the TeleFire unit from 'Safe' to 'Arm', at which point
                it will start "chirping" to indicate that it is "armed and