if [ -x ../ao-tools/ao-load/ao-load ]; then
AOLOAD=../ao-tools/ao-load/ao-load
elif [ -x /usr/bin/ao-load ]; then
if [ -x ../ao-tools/ao-load/ao-load ]; then
AOLOAD=../ao-tools/ao-load/ao-load
elif [ -x /usr/bin/ao-load ]; then
-echo "TeleBT v0.1 Turn-On and Calibration Program"
-echo "Copyright 2011 by Bdale Garbee. Released under GPL v2"
+echo "TeleBT v1.1 Turn-On and Calibration Program"
+echo "Copyright 2013 by Bdale Garbee. Released under GPL v2"
-echo "\tTeleBT v0.1 powered from USB"
-echo "\t\twith TeleDonle (on /dev/ttyACM0) cabled to debug header"
+echo "\tTeleBT v1.1 powered from USB"
+echo "\t\twith TeleDonlge (on /dev/ttyACM0) cabled to debug header"
echo -n "Generating RF carrier. Please enter measured frequency: "
read FREQ
CAL_VALUE=`nickle -e "floor(434.55 / $FREQ * 1186611 + 0.5)"`
echo "Programming flash with cal value " $CAL_VALUE
echo -n "Generating RF carrier. Please enter measured frequency: "
read FREQ
CAL_VALUE=`nickle -e "floor(434.55 / $FREQ * 1186611 + 0.5)"`
echo "Programming flash with cal value " $CAL_VALUE
-echo "Unplug and replug USB, cu to the board, confirm freq and record power"
+echo "Unplug debug cable, power cycle, cu to the board, confirm freq and record power"