1 altos (0.6+88+gdeccc10) unstable; urgency=low
3 * add gawk as a build dependency since strtonum is a gawk extension
5 -- Bdale Garbee <bdale@gag.com> Wed, 24 Feb 2010 16:44:35 -0700
7 altos (0.6+86+g2491282) unstable; urgency=low
10 * Disable monitor mode before attempting radio test.
11 * Ensure that ao_alarm waits at least the specified time
12 * Remove dbg driver code from telemetrum/teledongle
13 * Add AT45DBxx1D driver
14 * Remove green LED and temp sensor from v0.2 code
15 * Add at45db161d.h header file for new flash part.
16 * Add 'f' command to display flash status register contents
17 * Dump more flash parameters for the flash_status command
18 * Dump config block from read/write config and flash_status commands
19 * Don't set ao_flash_setup_done until we're actually done.
20 * Remove flash debugging printfs
21 * Add simple gps dump command 'g'
22 * Force idle mode by shorting the SPI clock to ground at boot time.
23 * Switch to using internal cc1111 temperature sensor
24 * Missing ao_mutex_put in gps_dump
25 * Compute daytime using GPS as time base
26 * Pull in a bit more data for filtering the start of the boost
27 * Log GPS data on pad after boost detect.
28 * Change barometer conversion code to shrink conversion table
29 * Change altos build process to support per-product compile-time
31 * Update .gitignore files
33 * Add back stack size checking to altos linking phase
34 * Must install .map files for ao-load to work
36 -- Bdale Garbee <bdale@gag.com> Wed, 24 Feb 2010 14:53:01 -0700
38 altos (0.6+60+g10d1bbc) unstable; urgency=low
41 * Use ao_radio_get/ao_radio_put in packet code.
43 -- Bdale Garbee <bdale@gag.com> Sat, 19 Dec 2009 13:53:32 -0700
45 altos (0.6+58+gbbb152c) unstable; urgency=low
48 * Re-order config values. Change frequency to cal
49 * Allow radio calibration to be set from ao-load
50 * Add --cal to man page
52 -- Bdale Garbee <bdale@gag.com> Sat, 19 Dec 2009 12:05:26 -0700
54 altos (0.6+53+gcd49847) unstable; urgency=low
57 * Remove send_serial and serial_baud commands.
58 * Make ao_cmd_decimal produce both 32 and 16 bit values.
59 * Add radio calibration configuration.
61 -- Bdale Garbee <bdale@gag.com> Sat, 05 Dec 2009 11:02:49 -0700
63 altos (0.6+49+g9a1d7dd) unstable; urgency=low
66 * Change default callsign to "N0CALL"
68 -- Bdale Garbee <bdale@gag.com> Fri, 04 Dec 2009 21:01:55 -0700
70 altos (0.6+47+g4053309) unstable; urgency=low
72 * fix absolute path in debian/dirs, add Suggests for slim-altusmetrum
73 * change home URL in control file to be the AltOS page
75 -- Bdale Garbee <bdale@gag.com> Thu, 26 Nov 2009 11:15:47 -0700
77 altos (0.6+43+gd6ba07e) unstable; urgency=low
80 * Decode HDOP data from skytraq GPS
81 * Document ao-postflight --gps and --kml options.
82 * Make ao-postflight create filenames using input filenames.
83 * Make TD print 0000-00-00 for invalid dates.
84 * Fix --plot arg handling. Add -all option.
85 * Convert telemetry file GPS satellite information in cc_log_read
86 * Don't crash if --plot isn't passed on ao-postflight command line
87 * ao-postflight: compute barometric alt for each GPS position
88 * ao-postflight: don't try to use missing gps sat data
89 * Automatically extract flight number for eeprom and telem filenames.
91 -- Bdale Garbee <bdale@gag.com> Sun, 22 Nov 2009 10:18:26 -0700
93 altos (0.6+32+g87e6f3e) unstable; urgency=low
99 * Reduce igniter firing time from 500ms to 50ms.
100 * Add GPS date/time output to ao-postflight.
101 * Eliminate SiRF state values from ao-view.
103 -- Bdale Garbee <bdale@gag.com> Fri, 20 Nov 2009 13:18:06 -0700
105 altos (0.6+27+gb0d7e3f) unstable; urgency=low
108 * Add two-point accelerometer calibration.
109 * Remove "l" command as ao-dumplong no longer uses it
112 * Reformat ADC values to show all 16 bits
113 * ao_flight_test was using accel value for pressure too
114 * Pass accel calibration over telemetry stream. Telemetry data format
116 * Add ability to dump eeprom data over radio link.
117 * In packet master, move USB flush from packet thread to echo thread
118 * In USB pollchar, wait for packet before re-checking USB out len
119 * Explicitly use USB I/O routines in packet code
120 * Flush pending input when switching to remote packet mode
121 * Stop recording in ao-dumplog after receiving an invalid block
122 * Move ao_match_word from ao_ignite.c to ao_cmd.c
123 * Add Watchdog Timer Control register definitions
124 * Add reboot command.
125 * Return radio to telemetry settings when packet system closed.
126 * ao-postflight: fix sloppy gps sat data realloc code (was crashing).
127 * Loosen tolerances for main->landed transition
128 * Provide a dummy 'uninstall' target in the src directory.
129 * Share telemetry parsing code in cc library.
130 * Enable telemetry receive in ao_view
131 * Switch order of serial/flight in ao-postflight summary
132 * Add flight number to telemetry stream.
133 * Add date to GPS data, captured from GPRMC packet.
134 * Stop using SiRF state info.
136 -- Bdale Garbee <bdale@gag.com> Fri, 20 Nov 2009 11:43:56 -0700
138 altos (0.6) unstable; urgency=low
141 * Add support for the SkyTraq GPS unit
142 * Build two versions of TM, one for SiRF, one for SkyTraq
143 * Save some DSEG space by marking cmd functions __reentrant
144 * Add ao_wake_task and ao_exit
145 * Add keyhole-markup generation for ao-postflight.
146 * Initial packet bits. Just testing transmission
147 * Add radio carrier command
148 * Wait for TX to finish sending data
150 * Remove reason from ao_dma_abort
151 * Switch packet code from timer thread to ao_alarm
152 * Use ao_radio_done to wait for TX to completely finish with packet
153 * Send SYN packet to set sequence numbers
155 * Do more flushing in packet test code
156 * Use ao_alarm for ao_delay so it can be easily interrupted
157 * Poke master to speed up packet rate when things are busy
158 * No need to wakeup &ao_tick_count now
159 * Enable packet-based communcation to command processor
160 * Add more docs to the README file
161 * Disable interrupts while removing tasks from task list
162 * Add ao_usb_pollchar to ao.h
164 -- Bdale Garbee <bdale@gag.com> Mon, 02 Nov 2009 16:53:45 -0700
166 altos (0.5+90+g127c312) unstable; urgency=low
168 * de-version the libreadline-dev build dependency
170 -- Bdale Garbee <bdale@gag.com> Mon, 02 Nov 2009 15:57:29 -0700
172 altos (0.5+86+g2de548f) unstable; urgency=low
174 * automate push of updated and tagged master branch during
175 debian/rules prebuild
176 * flush repetitive junk out of debian/changelog, and update the
178 * add support for tagging git repository on each Debian package build
180 -- Bdale Garbee <bdale@gag.com> Mon, 12 Oct 2009 16:54:28 -0600
182 altos (0.5+77+gc57bd7f) unstable; urgency=low
184 * build for Debian from git
186 -- Bdale Garbee <bdale@gag.com> Mon, 12 Oct 2009 15:57:19 -0600