1 altos (0.6+111+g20d4d41) unstable; urgency=low
3 * move gbp.conf into debian/
4 * initial harness for documentation
6 -- Bdale Garbee <bdale@gag.com> Tue, 30 Mar 2010 23:13:02 -0600
8 altos (0.6+108+g6e61170) unstable; urgency=low
11 * Need to duplicate new altitude conversion code in aoview.
13 -- Bdale Garbee <bdale@gag.com> Thu, 04 Mar 2010 17:33:27 -0700
15 altos (0.6+106+ga1478f6) unstable; urgency=low
18 * Add ao_radio_xmit to help test boards without flashing them.
19 * Allow product names to have suffixes (like board revisions)
20 * Fix and document the ao-rawload --run flag
22 * Leave .ihx files in the build directory too - easier to debug that way
23 * Eliminate deadlock when writing config from radio link
24 * Fix up LED colors for each product.
25 * Add .gitignore for ao-bringup
28 * create a turn on script for lighting up TeleDongle v0.2 boards
30 -- Bdale Garbee <bdale@gag.com> Sat, 27 Feb 2010 17:35:32 -0700
32 altos (0.6+95+g2f45953) unstable; urgency=low
34 * update changelogs for Debian build
35 * conditionalize use of git on executability of /usr/bin/git binary
37 -- Bdale Garbee <bdale@gag.com> Wed, 24 Feb 2010 17:30:00 -0700
39 altos (0.6+88+gdeccc10) unstable; urgency=low
41 * add gawk as a build dependency since strtonum is a gawk extension
43 -- Bdale Garbee <bdale@gag.com> Wed, 24 Feb 2010 16:44:35 -0700
45 altos (0.6+86+g2491282) unstable; urgency=low
48 * Disable monitor mode before attempting radio test.
49 * Ensure that ao_alarm waits at least the specified time
50 * Remove dbg driver code from telemetrum/teledongle
51 * Add AT45DBxx1D driver
52 * Remove green LED and temp sensor from v0.2 code
53 * Add at45db161d.h header file for new flash part.
54 * Add 'f' command to display flash status register contents
55 * Dump more flash parameters for the flash_status command
56 * Dump config block from read/write config and flash_status commands
57 * Don't set ao_flash_setup_done until we're actually done.
58 * Remove flash debugging printfs
59 * Add simple gps dump command 'g'
60 * Force idle mode by shorting the SPI clock to ground at boot time.
61 * Switch to using internal cc1111 temperature sensor
62 * Missing ao_mutex_put in gps_dump
63 * Compute daytime using GPS as time base
64 * Pull in a bit more data for filtering the start of the boost
65 * Log GPS data on pad after boost detect.
66 * Change barometer conversion code to shrink conversion table
67 * Change altos build process to support per-product compile-time
69 * Update .gitignore files
71 * Add back stack size checking to altos linking phase
72 * Must install .map files for ao-load to work
74 -- Bdale Garbee <bdale@gag.com> Wed, 24 Feb 2010 14:53:01 -0700
76 altos (0.6+60+g10d1bbc) unstable; urgency=low
79 * Use ao_radio_get/ao_radio_put in packet code.
81 -- Bdale Garbee <bdale@gag.com> Sat, 19 Dec 2009 13:53:32 -0700
83 altos (0.6+58+gbbb152c) unstable; urgency=low
86 * Re-order config values. Change frequency to cal
87 * Allow radio calibration to be set from ao-load
88 * Add --cal to man page
90 -- Bdale Garbee <bdale@gag.com> Sat, 19 Dec 2009 12:05:26 -0700
92 altos (0.6+53+gcd49847) unstable; urgency=low
95 * Remove send_serial and serial_baud commands.
96 * Make ao_cmd_decimal produce both 32 and 16 bit values.
97 * Add radio calibration configuration.
99 -- Bdale Garbee <bdale@gag.com> Sat, 05 Dec 2009 11:02:49 -0700
101 altos (0.6+49+g9a1d7dd) unstable; urgency=low
104 * Change default callsign to "N0CALL"
106 -- Bdale Garbee <bdale@gag.com> Fri, 04 Dec 2009 21:01:55 -0700
108 altos (0.6+47+g4053309) unstable; urgency=low
110 * fix absolute path in debian/dirs, add Suggests for slim-altusmetrum
111 * change home URL in control file to be the AltOS page
113 -- Bdale Garbee <bdale@gag.com> Thu, 26 Nov 2009 11:15:47 -0700
115 altos (0.6+43+gd6ba07e) unstable; urgency=low
118 * Decode HDOP data from skytraq GPS
119 * Document ao-postflight --gps and --kml options.
120 * Make ao-postflight create filenames using input filenames.
121 * Make TD print 0000-00-00 for invalid dates.
122 * Fix --plot arg handling. Add -all option.
123 * Convert telemetry file GPS satellite information in cc_log_read
124 * Don't crash if --plot isn't passed on ao-postflight command line
125 * ao-postflight: compute barometric alt for each GPS position
126 * ao-postflight: don't try to use missing gps sat data
127 * Automatically extract flight number for eeprom and telem filenames.
129 -- Bdale Garbee <bdale@gag.com> Sun, 22 Nov 2009 10:18:26 -0700
131 altos (0.6+32+g87e6f3e) unstable; urgency=low
134 * fix typo in comment
137 * Reduce igniter firing time from 500ms to 50ms.
138 * Add GPS date/time output to ao-postflight.
139 * Eliminate SiRF state values from ao-view.
141 -- Bdale Garbee <bdale@gag.com> Fri, 20 Nov 2009 13:18:06 -0700
143 altos (0.6+27+gb0d7e3f) unstable; urgency=low
146 * Add two-point accelerometer calibration.
147 * Remove "l" command as ao-dumplong no longer uses it
150 * Reformat ADC values to show all 16 bits
151 * ao_flight_test was using accel value for pressure too
152 * Pass accel calibration over telemetry stream. Telemetry data format
154 * Add ability to dump eeprom data over radio link.
155 * In packet master, move USB flush from packet thread to echo thread
156 * In USB pollchar, wait for packet before re-checking USB out len
157 * Explicitly use USB I/O routines in packet code
158 * Flush pending input when switching to remote packet mode
159 * Stop recording in ao-dumplog after receiving an invalid block
160 * Move ao_match_word from ao_ignite.c to ao_cmd.c
161 * Add Watchdog Timer Control register definitions
162 * Add reboot command.
163 * Return radio to telemetry settings when packet system closed.
164 * ao-postflight: fix sloppy gps sat data realloc code (was crashing).
165 * Loosen tolerances for main->landed transition
166 * Provide a dummy 'uninstall' target in the src directory.
167 * Share telemetry parsing code in cc library.
168 * Enable telemetry receive in ao_view
169 * Switch order of serial/flight in ao-postflight summary
170 * Add flight number to telemetry stream.
171 * Add date to GPS data, captured from GPRMC packet.
172 * Stop using SiRF state info.
174 -- Bdale Garbee <bdale@gag.com> Fri, 20 Nov 2009 11:43:56 -0700
176 altos (0.6) unstable; urgency=low
179 * Add support for the SkyTraq GPS unit
180 * Build two versions of TM, one for SiRF, one for SkyTraq
181 * Save some DSEG space by marking cmd functions __reentrant
182 * Add ao_wake_task and ao_exit
183 * Add keyhole-markup generation for ao-postflight.
184 * Initial packet bits. Just testing transmission
185 * Add radio carrier command
186 * Wait for TX to finish sending data
188 * Remove reason from ao_dma_abort
189 * Switch packet code from timer thread to ao_alarm
190 * Use ao_radio_done to wait for TX to completely finish with packet
191 * Send SYN packet to set sequence numbers
193 * Do more flushing in packet test code
194 * Use ao_alarm for ao_delay so it can be easily interrupted
195 * Poke master to speed up packet rate when things are busy
196 * No need to wakeup &ao_tick_count now
197 * Enable packet-based communcation to command processor
198 * Add more docs to the README file
199 * Disable interrupts while removing tasks from task list
200 * Add ao_usb_pollchar to ao.h
202 -- Bdale Garbee <bdale@gag.com> Mon, 02 Nov 2009 16:53:45 -0700
204 altos (0.5+90+g127c312) unstable; urgency=low
206 * de-version the libreadline-dev build dependency
208 -- Bdale Garbee <bdale@gag.com> Mon, 02 Nov 2009 15:57:29 -0700
210 altos (0.5+86+g2de548f) unstable; urgency=low
212 * automate push of updated and tagged master branch during
213 debian/rules prebuild
214 * flush repetitive junk out of debian/changelog, and update the
216 * add support for tagging git repository on each Debian package build
218 -- Bdale Garbee <bdale@gag.com> Mon, 12 Oct 2009 16:54:28 -0600
220 altos (0.5+77+gc57bd7f) unstable; urgency=low
222 * build for Debian from git
224 -- Bdale Garbee <bdale@gag.com> Mon, 12 Oct 2009 15:57:19 -0600