afar, as if it were directly connected to the computer.
</para>
<para>
- Any operation which can be performed with TeleMetrum
- can either be done with TeleMetrum directly connected to
- the computer via the USB cable, or through the packet
- link. Simply select the appropriate TeleDongle device when
- the list of devices is presented and AltosUI will use packet
- command mode.
+ Any operation which can be performed with TeleMetrum can
+ either be done with TeleMetrum directly connected to the
+ computer via the USB cable, or through the packet
+ link. TeleMini doesn't provide a USB connector and so it can
+ only be controlled through the packet link. Select the
+ appropriate TeleDongle device when the list of devices is
+ presented and AltosUI will use packet command mode.
</para>
<para>
One oddity in the current interface is how AltosUI selects the
TeleMini listens for a command packet for five seconds after
first being turned on, if it doesn't hear anything, it enters
'pad' mode, ready for flight and will no longer listen for
- command packets.
+ command packets. The easiest way to connect to TeleMini is to
+ initiate the command and select the TeleDongle device. At this
+ point, the TeleDongle will be attempting to communicate with
+ the TeleMini. Now turn TeleMini on, and it should immediately
+ start communicating with the TeleDongle and the desired
+ operation can be performed.
</para>
<para>
When packet command mode is enabled, you can monitor the link