The flash recovery section explained which pins to connect, but lacked
explicit instructions on how to make it work.
</listitem>
</varlistentry>
</variablelist>
+ <para>
+ Once you've located the right pins:
+ </para>
+ <orderedlist inheritnum='inherit' numeration='arabic'>
+ <listitem>
+ <para>
+ Turn the altimeter power off.
+ </para>
+ </listitem>
+ <listitem>
+ <para>
+ Connect a battery.
+ </para>
+ </listitem>
+ <listitem>
+ <para>
+ Connect the indicated terminals together with a short
+ piece of wire. Take care not to accidentally connect
+ anything else.
+ </para>
+ </listitem>
+ <listitem>
+ <para>
+ Connect USB
+ </para>
+ </listitem>
+ <listitem>
+ <para>
+ Turn the board power on.
+ </para>
+ </listitem>
+ <listitem>
+ <para>
+ The board should now be visible over USB as 'AltosFlash'
+ and be ready to receive firmware.
+ </para>
+ </listitem>
+ <listitem>
+ <para>
+ Once the board has been powered up, you can remove the
+ piece of wire.
+ </para>
+ </listitem>
+ </orderedlist>
</section>
</section>
<section>