drivers/bcm2835gpio: Migrate to adapter gpio commands

[fw/openocd] / tcl / interface / jtag_hat_rpi2.cfg

diff --git a/tcl/interface/jtag_hat_rpi2.cfg b/tcl/interface/jtag_hat_rpi2.cfg
index 495ff0f042da09fc122a7d0d84cd46e1f6ebd3a9..cd1cbfb8af1ab533749713ec40a13627f88dcac1 100644 (file)
--- a/tcl/interface/jtag_hat_rpi2.cfg
+++ b/tcl/interface/jtag_hat_rpi2.cfg
@@ -7,31 +7,35 @@
 
 adapter driver bcm2835gpio
 
-bcm2835gpio_peripheral_base 0x3F000000
+bcm2835gpio peripheral_base 0x3F000000
 
 # Transition delay calculation: SPEED_COEFF/khz - SPEED_OFFSET
 # These depend on system clock, calibrated for stock 700MHz
 # bcm2835gpio_speed SPEED_COEFF SPEED_OFFSET
-bcm2835gpio_speed_coeffs 146203 36
+bcm2835gpio speed_coeffs 146203 36
 
 # Each of the JTAG lines need a gpio number set: tck tms tdi tdo
 # Header pin numbers: 23 22 19 21
-bcm2835gpio_jtag_nums 11 25 10 9
+adapter gpio tck -chip 0 11
+adapter gpio tms -chip 0 25
+adapter gpio tdi -chip 0 10
+adapter gpio tdo -chip 0 9
 
 # Each of the SWD lines need a gpio number set: swclk swdio
 # Header pin numbers: 23 22
-bcm2835gpio_swd_nums 11 25
+adapter gpio swclk -chip 0 11
+adapter gpio swdio -chip 0 25
 
 # Direction pin for SWDIO level shifting buffer
-bcm2835gpio_swdio_dir_num 6
+adapter gpio swdio_dir -chip 0 6
 
 # If you define trst or srst, use appropriate reset_config
 # Header pin numbers: TRST - 26, SRST - 18
 
-bcm2835gpio_trst_num 7
+adapter gpio trst -chip 0 7
 #reset_config trst_only
 
-bcm2835gpio_srst_num 24
+adapter gpio srst -chip 0 24
 #reset_config srst_only
 
 # or if you have both connected