From: Keith Packard Date: Sat, 2 Mar 2013 04:45:43 +0000 (-0800) Subject: doc: Document how to get TeleMini to 'emergency recovery' mode X-Git-Tag: altosdroid_v1.2-1~100 X-Git-Url: https://git.gag.com/?p=fw%2Faltos;a=commitdiff_plain;h=c9cba68049f957d69a88150470c086dd6f4a42c0 doc: Document how to get TeleMini to 'emergency recovery' mode TeleMini needs emergency recovery mode in case you forget the radio parameters and need to get things back to a known state. Add documentation to describe what this does and how to get it enabled. Signed-off-by: Keith Packard --- diff --git a/doc/altusmetrum.xsl b/doc/altusmetrum.xsl index 9fdd6b07..e696da79 100644 --- a/doc/altusmetrum.xsl +++ b/doc/altusmetrum.xsl @@ -386,6 +386,36 @@ NAR #88757, TRA #12200 tower with a screw-driver trying to turn on your avionics before installing igniters! + + TeleMini is configured via the radio link. Of course, that + means you need to know the TeleMini radio configuration values + or you won't be able to communicate with it. For situations + when you don't have the radio configuration values, TeleMini + offers an 'emergency recovery' mode. In this mode, TeleMini is + configured as follows: + + + Sets the radio frequency to 434.550MHz + + + Sets the radio calibration back to the factory value. + + + Sets the callsign to N0CALL + + + Does not go to 'pad' mode after five seconds. + + + + + To get into 'emergency recovery' mode, first find the row of + four small holes opposite the switch wiring. Using a short + piece of small gauge wire, connect the outer two holes + together, then power TeleMini up. Once the red LED is lit, + disconnect the wire and the board should signal that it's in + 'idle' mode after the initial five second startup period. +
GPS