doc: Update micropeak quick start guide to note new boost detect

Now waits for one minute and 30m of altitude change to avoid false detections.

Signed-off-by: Keith Packard <keithp@keithp.com>

diff --git a/doc/micropeak.xsl b/doc/micropeak.xsl
index afa6fd1575fdba714407535d2610c239d5b904ab..cd9452c851a3f5f3dbde2b0045768f89daa52529 100644 (file)
--- a/doc/micropeak.xsl
+++ b/doc/micropeak.xsl
@@ -115,20 +115,20 @@ NAR #88757, TRA #12200
        <para>
          Finish preparing the rocket for flight. After the
          previous flight data have been reported, MicroPeak waits for
-         30 seconds before starting to check for launch. This gives
+         one minute before starting to check for launch. This gives
          you time to finish assembling the rocket. As those
          activities might cause pressure changes inside the airframe,
          MicroPeak might accidentally detect boost. If you need to do
-         anything to the airframe after the 30 second window passes,
+         anything to the airframe after the one minute window passes,
          make sure to be careful not to disturb the altimeter. The
-         LED will remain dark during the 30 second delay, but after
+         LED will remain dark during the one minute delay, but after
          that, it will start blinking once every 3 seconds.
        </para>
       </listitem>
       <listitem>
        <para>
-         Fly the rocket. Once the rocket passes about 10m in height
-         (32 feet), the micro-controller will record the ground
+         Fly the rocket. Once the rocket passes about 30m in height
+         (100 feet), the micro-controller will record the ground
          pressure and track the pressure seen during the flight. In
          this mode, the LED flickers rapidly. When the rocket lands,
          and the pressure stabilizes, the micro-controller will record