Break out common pieces from TeleGPS and AltusMetrum

[fw/altos] / doc / telegps-quick-start.inc

diff --git a/doc/telegps-quick-start.inc b/doc/telegps-quick-start.inc
index e8db8ac358197c866da520de41bafb31044b0cec..6492743d68a173c97c12108bda55d7492f043d2d 100644 (file)
--- a/doc/telegps-quick-start.inc
+++ b/doc/telegps-quick-start.inc
@@ -3,22 +3,21 @@
        TeleGPS is designed to be easy to use. Requiring no external
        components, flying takes just a few steps.
 
-       First, download and install the software from
+       1. First, download and install the software from
        http://altusmetrum.org/AltOS. This will make sure that
        you have the right device drivers installed.
 
-       Next, plug in the battery and USB cable and connect TeleGPS to
+       2. Next, plug in the battery and USB cable and connect TeleGPS to
        your computer. This will charge the battery and allow you to
        configure the device.
 
-       Start the TeleGPS application and set the callsign and frequency
-       on your TeleGPS device; refer to the Configure TeleGPS section
-       in the TeleGPS Application chapter for instructions.
+       3. Start the TeleGPS application and set the callsign and frequency
+       on your TeleGPS device; refer to <<_configure_device>> for instructions.
 
-       Unplug TeleGPS when the battery charger light goes green. This
+       4. Unplug TeleGPS when the battery charger light goes green. This
        will enable the radio and logging portions of the TeleGPS
        firmware.
 
-       Connect TeleDongle to your computer and start TeleGPS or start
+       5. Connect TeleDongle to your computer and start TeleGPS or start
        AltosDroid on your android device and connect to TeleBT. Set the
        frequency to match the TeleGPS and you should be receiving telemetry.