<section>
<title>Configure Altimeter</title>
<para>
- Select this button and then select either a TeleMetrum or
+ Select this button and then select either an altimeter or
TeleDongle Device from the list provided. Selecting a TeleDongle
device will use the radio link to configure a remote altimeter.
</para>
<section>
<title>Radio Frequency</title>
<para>
- This configures which of the configured frequencies to use for both
+ This configures which of the frequencies to use for both
telemetry and packet command mode. Note that if you set this
- value via packet command mode, you will have to reconfigure
- the TeleDongle frequency before you will be able to use packet
- command mode again.
+ value via packet command mode, the TeleDongle frequency will
+ also be automatically reconfigured to match so that
+ communication will continue afterwards.
</para>
</section>
<section>
- <title>Radio Calibration</title>
+ <title>RF Calibration</title>
<para>
The radios in every Altus Metrum device are calibrated at the
factory to ensure that they transmit and receive on the
you must reprogram the unit completely.
</para>
</section>
+ <section>
+ <title>Telemetry/RDF/APRS Enable</title>
+ <para>
+ Enables the radio for transmission during flight. When
+ disabled, the radio will not transmit anything during flight
+ at all.
+ </para>
+ </section>
+ <section>
+ <title>APRS Interval</title>
+ <para>
+ How often to transmit GPS information via APRS. This option
+ is available on TeleMetrum v2 and TeleMega
+ boards. TeleMetrum v1 boards cannot transmit APRS
+ packets. Note that a single APRS packet takes nearly a full
+ second to transmit, so enabling this option will prevent
+ sending any other telemetry during that time.
+ </para>
+ </section>
<section>
<title>Callsign</title>
<para>
</listitem>
</itemizedlist>
</section>
+ <section>
+ <title>Configure Pyro Channels</title>
+ <para>
+ This opens a separate window to configure the additional
+ pyro channels available on TeleMega. One column is presented
+ for each channel. Each row represents a single parameter, if
+ enabled the parameter must meet the specified test for the
+ pyro channel to be fired.
+ </para>
+ <itemizedlist>
+ <listitem>
+ <para>
+
+ </para>
+ </listitem>
+ </itemizedlist>
+ </section>
</section>
<section>
<title>Configure AltosUI</title>