[appendix]
== Troubleshooting

	=== TeleFire Fails to Arm

		If turning the TeleLCO key switch from "SAFE" to "ARM" does
		not cause the selected TeleFire box to start flashing and
		sounding its siren, the most likely cause is that the 
		TeleFire box was left with the local safe/arm switch in the
		safe position.  The Remote Arm LED on TeleLCO shows the state
		of the safe/arm switch on the currently selected TeleFire box
		and can be used to confirm this situation.

		Note that in a cross-bank drag race configuration, any TeleFire
		boxes involved in the drag race that are fully armed will
		launch, while any TeleFire boxes involved in the drag race
		that are not fully armed will not launch.  Pay attention to
		make sure all involved TeleFire boxes are flashing their
		strobe lights and sounding their sirens before launch to
		ensure all desired rockets will actually participate in such
		a drag race.

	=== Radio Signal Strength

		Each unit in the TeleLaunch system has a debugging feature
		that can be used to view the actual received radio signal 
		strength of each packet.  To use this feature, connect to the
		desired unit (TeleLCO is probably the most useful place to
		start) with a laptop and terminal program as explained in the
		configuration section of the manual.  Then, you can enable
		debug tracing using 'D 1' command.

		Debug mode is fairly chatty, but each time the TeleLCO unit
		queries the currently selected TeleFire unit for igniter
		status, the return packet will print out the RSSI value.
		RSSI is "received signal strength indicated" and is expressed
		in decibel units relative to a milliwatt, or "dBm".  

		Observing the RSSI is a great way to compare antennas, antenna
		mounting arrangements, and so forth with more granularity than
		provided by the red/amber/green operational LED indicators.

		The system is good down to below -100dBm, and it takes about 
		6dB to double the range.  So a reading of -80dBm means that you
		could extend the distance between the units by a factor of
		10 before losing the link.  Note, however, that real world
		range is affected by terrain, vegetation, etc.  And you really
		don't ever want to be operating close to the minimum signal
		threshold!  Keep the RF signal indicators green with good
		antenna choices and installations for maximum satisfaction.