altos (0.6+108+g6e61170) unstable; urgency=low [ Keith Packard ] * Need to duplicate new altitude conversion code in aoview. -- Bdale Garbee Thu, 04 Mar 2010 17:33:27 -0700 altos (0.6+106+ga1478f6) unstable; urgency=low [ Keith Packard ] * Add ao_radio_xmit to help test boards without flashing them. * Allow product names to have suffixes (like board revisions) * Fix and document the ao-rawload --run flag * Add LED test * Leave .ihx files in the build directory too - easier to debug that way * Eliminate deadlock when writing config from radio link * Fix up LED colors for each product. * Add .gitignore for ao-bringup [ Bdale Garbee ] * create a turn on script for lighting up TeleDongle v0.2 boards -- Bdale Garbee Sat, 27 Feb 2010 17:35:32 -0700 altos (0.6+95+g2f45953) unstable; urgency=low * update changelogs for Debian build * conditionalize use of git on executability of /usr/bin/git binary -- Bdale Garbee Wed, 24 Feb 2010 17:30:00 -0700 altos (0.6+88+gdeccc10) unstable; urgency=low * add gawk as a build dependency since strtonum is a gawk extension -- Bdale Garbee Wed, 24 Feb 2010 16:44:35 -0700 altos (0.6+86+g2491282) unstable; urgency=low [ Keith Packard ] * Disable monitor mode before attempting radio test. * Ensure that ao_alarm waits at least the specified time * Remove dbg driver code from telemetrum/teledongle * Add AT45DBxx1D driver * Remove green LED and temp sensor from v0.2 code * Add at45db161d.h header file for new flash part. * Add 'f' command to display flash status register contents * Dump more flash parameters for the flash_status command * Dump config block from read/write config and flash_status commands * Don't set ao_flash_setup_done until we're actually done. * Remove flash debugging printfs * Add simple gps dump command 'g' * Force idle mode by shorting the SPI clock to ground at boot time. * Switch to using internal cc1111 temperature sensor * Missing ao_mutex_put in gps_dump * Compute daytime using GPS as time base * Pull in a bit more data for filtering the start of the boost * Log GPS data on pad after boost detect. * Change barometer conversion code to shrink conversion table * Change altos build process to support per-product compile-time changes * Update .gitignore files * Quiet make output. * Add back stack size checking to altos linking phase * Must install .map files for ao-load to work -- Bdale Garbee Wed, 24 Feb 2010 14:53:01 -0700 altos (0.6+60+g10d1bbc) unstable; urgency=low [ Keith Packard ] * Use ao_radio_get/ao_radio_put in packet code. -- Bdale Garbee Sat, 19 Dec 2009 13:53:32 -0700 altos (0.6+58+gbbb152c) unstable; urgency=low [ Keith Packard ] * Re-order config values. Change frequency to cal * Allow radio calibration to be set from ao-load * Add --cal to man page -- Bdale Garbee Sat, 19 Dec 2009 12:05:26 -0700 altos (0.6+53+gcd49847) unstable; urgency=low [ Keith Packard ] * Remove send_serial and serial_baud commands. * Make ao_cmd_decimal produce both 32 and 16 bit values. * Add radio calibration configuration. -- Bdale Garbee Sat, 05 Dec 2009 11:02:49 -0700 altos (0.6+49+g9a1d7dd) unstable; urgency=low [ Keith Packard ] * Change default callsign to "N0CALL" -- Bdale Garbee Fri, 04 Dec 2009 21:01:55 -0700 altos (0.6+47+g4053309) unstable; urgency=low * fix absolute path in debian/dirs, add Suggests for slim-altusmetrum * change home URL in control file to be the AltOS page -- Bdale Garbee Thu, 26 Nov 2009 11:15:47 -0700 altos (0.6+43+gd6ba07e) unstable; urgency=low [ Keith Packard ] * Decode HDOP data from skytraq GPS * Document ao-postflight --gps and --kml options. * Make ao-postflight create filenames using input filenames. * Make TD print 0000-00-00 for invalid dates. * Fix --plot arg handling. Add -all option. * Convert telemetry file GPS satellite information in cc_log_read * Don't crash if --plot isn't passed on ao-postflight command line * ao-postflight: compute barometric alt for each GPS position * ao-postflight: don't try to use missing gps sat data * Automatically extract flight number for eeprom and telem filenames. -- Bdale Garbee Sun, 22 Nov 2009 10:18:26 -0700 altos (0.6+32+g87e6f3e) unstable; urgency=low [ Bdale Garbee ] * fix typo in comment [ Keith Packard ] * Reduce igniter firing time from 500ms to 50ms. * Add GPS date/time output to ao-postflight. * Eliminate SiRF state values from ao-view. -- Bdale Garbee Fri, 20 Nov 2009 13:18:06 -0700 altos (0.6+27+gb0d7e3f) unstable; urgency=low [ Keith Packard ] * Add two-point accelerometer calibration. * Remove "l" command as ao-dumplong no longer uses it * Remove "d" command * Remove "f" command * Reformat ADC values to show all 16 bits * ao_flight_test was using accel value for pressure too * Pass accel calibration over telemetry stream. Telemetry data format change. * Add ability to dump eeprom data over radio link. * In packet master, move USB flush from packet thread to echo thread * In USB pollchar, wait for packet before re-checking USB out len * Explicitly use USB I/O routines in packet code * Flush pending input when switching to remote packet mode * Stop recording in ao-dumplog after receiving an invalid block * Move ao_match_word from ao_ignite.c to ao_cmd.c * Add Watchdog Timer Control register definitions * Add reboot command. * Return radio to telemetry settings when packet system closed. * ao-postflight: fix sloppy gps sat data realloc code (was crashing). * Loosen tolerances for main->landed transition * Provide a dummy 'uninstall' target in the src directory. * Share telemetry parsing code in cc library. * Enable telemetry receive in ao_view * Switch order of serial/flight in ao-postflight summary * Add flight number to telemetry stream. * Add date to GPS data, captured from GPRMC packet. * Stop using SiRF state info. -- Bdale Garbee Fri, 20 Nov 2009 11:43:56 -0700 altos (0.6) unstable; urgency=low [ Keith Packard ] * Add support for the SkyTraq GPS unit * Build two versions of TM, one for SiRF, one for SkyTraq * Save some DSEG space by marking cmd functions __reentrant * Add ao_wake_task and ao_exit * Add keyhole-markup generation for ao-postflight. * Initial packet bits. Just testing transmission * Add radio carrier command * Wait for TX to finish sending data * Add ao_alarm * Remove reason from ao_dma_abort * Switch packet code from timer thread to ao_alarm * Use ao_radio_done to wait for TX to completely finish with packet * Send SYN packet to set sequence numbers * Add RFIM register * Do more flushing in packet test code * Use ao_alarm for ao_delay so it can be easily interrupted * Poke master to speed up packet rate when things are busy * No need to wakeup &ao_tick_count now * Enable packet-based communcation to command processor * Add more docs to the README file * Disable interrupts while removing tasks from task list * Add ao_usb_pollchar to ao.h -- Bdale Garbee Mon, 02 Nov 2009 16:53:45 -0700 altos (0.5+90+g127c312) unstable; urgency=low * de-version the libreadline-dev build dependency -- Bdale Garbee Mon, 02 Nov 2009 15:57:29 -0700 altos (0.5+86+g2de548f) unstable; urgency=low * automate push of updated and tagged master branch during debian/rules prebuild * flush repetitive junk out of debian/changelog, and update the prebuild target * add support for tagging git repository on each Debian package build -- Bdale Garbee Mon, 12 Oct 2009 16:54:28 -0600 altos (0.5+77+gc57bd7f) unstable; urgency=low * build for Debian from git -- Bdale Garbee Mon, 12 Oct 2009 15:57:19 -0600