1 altos (0.6+106+ga1478f6) unstable; urgency=low
4 * Add ao_radio_xmit to help test boards without flashing them.
5 * Allow product names to have suffixes (like board revisions)
6 * Fix and document the ao-rawload --run flag
8 * Leave .ihx files in the build directory too - easier to debug that way
9 * Eliminate deadlock when writing config from radio link
10 * Fix up LED colors for each product.
11 * Add .gitignore for ao-bringup
14 * create a turn on script for lighting up TeleDongle v0.2 boards
16 -- Bdale Garbee <bdale@gag.com> Sat, 27 Feb 2010 17:35:32 -0700
18 altos (0.6+95+g2f45953) unstable; urgency=low
20 * update changelogs for Debian build
21 * conditionalize use of git on executability of /usr/bin/git binary
23 -- Bdale Garbee <bdale@gag.com> Wed, 24 Feb 2010 17:30:00 -0700
25 altos (0.6+88+gdeccc10) unstable; urgency=low
27 * add gawk as a build dependency since strtonum is a gawk extension
29 -- Bdale Garbee <bdale@gag.com> Wed, 24 Feb 2010 16:44:35 -0700
31 altos (0.6+86+g2491282) unstable; urgency=low
34 * Disable monitor mode before attempting radio test.
35 * Ensure that ao_alarm waits at least the specified time
36 * Remove dbg driver code from telemetrum/teledongle
37 * Add AT45DBxx1D driver
38 * Remove green LED and temp sensor from v0.2 code
39 * Add at45db161d.h header file for new flash part.
40 * Add 'f' command to display flash status register contents
41 * Dump more flash parameters for the flash_status command
42 * Dump config block from read/write config and flash_status commands
43 * Don't set ao_flash_setup_done until we're actually done.
44 * Remove flash debugging printfs
45 * Add simple gps dump command 'g'
46 * Force idle mode by shorting the SPI clock to ground at boot time.
47 * Switch to using internal cc1111 temperature sensor
48 * Missing ao_mutex_put in gps_dump
49 * Compute daytime using GPS as time base
50 * Pull in a bit more data for filtering the start of the boost
51 * Log GPS data on pad after boost detect.
52 * Change barometer conversion code to shrink conversion table
53 * Change altos build process to support per-product compile-time
55 * Update .gitignore files
57 * Add back stack size checking to altos linking phase
58 * Must install .map files for ao-load to work
60 -- Bdale Garbee <bdale@gag.com> Wed, 24 Feb 2010 14:53:01 -0700
62 altos (0.6+60+g10d1bbc) unstable; urgency=low
65 * Use ao_radio_get/ao_radio_put in packet code.
67 -- Bdale Garbee <bdale@gag.com> Sat, 19 Dec 2009 13:53:32 -0700
69 altos (0.6+58+gbbb152c) unstable; urgency=low
72 * Re-order config values. Change frequency to cal
73 * Allow radio calibration to be set from ao-load
74 * Add --cal to man page
76 -- Bdale Garbee <bdale@gag.com> Sat, 19 Dec 2009 12:05:26 -0700
78 altos (0.6+53+gcd49847) unstable; urgency=low
81 * Remove send_serial and serial_baud commands.
82 * Make ao_cmd_decimal produce both 32 and 16 bit values.
83 * Add radio calibration configuration.
85 -- Bdale Garbee <bdale@gag.com> Sat, 05 Dec 2009 11:02:49 -0700
87 altos (0.6+49+g9a1d7dd) unstable; urgency=low
90 * Change default callsign to "N0CALL"
92 -- Bdale Garbee <bdale@gag.com> Fri, 04 Dec 2009 21:01:55 -0700
94 altos (0.6+47+g4053309) unstable; urgency=low
96 * fix absolute path in debian/dirs, add Suggests for slim-altusmetrum
97 * change home URL in control file to be the AltOS page
99 -- Bdale Garbee <bdale@gag.com> Thu, 26 Nov 2009 11:15:47 -0700
101 altos (0.6+43+gd6ba07e) unstable; urgency=low
104 * Decode HDOP data from skytraq GPS
105 * Document ao-postflight --gps and --kml options.
106 * Make ao-postflight create filenames using input filenames.
107 * Make TD print 0000-00-00 for invalid dates.
108 * Fix --plot arg handling. Add -all option.
109 * Convert telemetry file GPS satellite information in cc_log_read
110 * Don't crash if --plot isn't passed on ao-postflight command line
111 * ao-postflight: compute barometric alt for each GPS position
112 * ao-postflight: don't try to use missing gps sat data
113 * Automatically extract flight number for eeprom and telem filenames.
115 -- Bdale Garbee <bdale@gag.com> Sun, 22 Nov 2009 10:18:26 -0700
117 altos (0.6+32+g87e6f3e) unstable; urgency=low
120 * fix typo in comment
123 * Reduce igniter firing time from 500ms to 50ms.
124 * Add GPS date/time output to ao-postflight.
125 * Eliminate SiRF state values from ao-view.
127 -- Bdale Garbee <bdale@gag.com> Fri, 20 Nov 2009 13:18:06 -0700
129 altos (0.6+27+gb0d7e3f) unstable; urgency=low
132 * Add two-point accelerometer calibration.
133 * Remove "l" command as ao-dumplong no longer uses it
136 * Reformat ADC values to show all 16 bits
137 * ao_flight_test was using accel value for pressure too
138 * Pass accel calibration over telemetry stream. Telemetry data format
140 * Add ability to dump eeprom data over radio link.
141 * In packet master, move USB flush from packet thread to echo thread
142 * In USB pollchar, wait for packet before re-checking USB out len
143 * Explicitly use USB I/O routines in packet code
144 * Flush pending input when switching to remote packet mode
145 * Stop recording in ao-dumplog after receiving an invalid block
146 * Move ao_match_word from ao_ignite.c to ao_cmd.c
147 * Add Watchdog Timer Control register definitions
148 * Add reboot command.
149 * Return radio to telemetry settings when packet system closed.
150 * ao-postflight: fix sloppy gps sat data realloc code (was crashing).
151 * Loosen tolerances for main->landed transition
152 * Provide a dummy 'uninstall' target in the src directory.
153 * Share telemetry parsing code in cc library.
154 * Enable telemetry receive in ao_view
155 * Switch order of serial/flight in ao-postflight summary
156 * Add flight number to telemetry stream.
157 * Add date to GPS data, captured from GPRMC packet.
158 * Stop using SiRF state info.
160 -- Bdale Garbee <bdale@gag.com> Fri, 20 Nov 2009 11:43:56 -0700
162 altos (0.6) unstable; urgency=low
165 * Add support for the SkyTraq GPS unit
166 * Build two versions of TM, one for SiRF, one for SkyTraq
167 * Save some DSEG space by marking cmd functions __reentrant
168 * Add ao_wake_task and ao_exit
169 * Add keyhole-markup generation for ao-postflight.
170 * Initial packet bits. Just testing transmission
171 * Add radio carrier command
172 * Wait for TX to finish sending data
174 * Remove reason from ao_dma_abort
175 * Switch packet code from timer thread to ao_alarm
176 * Use ao_radio_done to wait for TX to completely finish with packet
177 * Send SYN packet to set sequence numbers
179 * Do more flushing in packet test code
180 * Use ao_alarm for ao_delay so it can be easily interrupted
181 * Poke master to speed up packet rate when things are busy
182 * No need to wakeup &ao_tick_count now
183 * Enable packet-based communcation to command processor
184 * Add more docs to the README file
185 * Disable interrupts while removing tasks from task list
186 * Add ao_usb_pollchar to ao.h
188 -- Bdale Garbee <bdale@gag.com> Mon, 02 Nov 2009 16:53:45 -0700
190 altos (0.5+90+g127c312) unstable; urgency=low
192 * de-version the libreadline-dev build dependency
194 -- Bdale Garbee <bdale@gag.com> Mon, 02 Nov 2009 15:57:29 -0700
196 altos (0.5+86+g2de548f) unstable; urgency=low
198 * automate push of updated and tagged master branch during
199 debian/rules prebuild
200 * flush repetitive junk out of debian/changelog, and update the
202 * add support for tagging git repository on each Debian package build
204 -- Bdale Garbee <bdale@gag.com> Mon, 12 Oct 2009 16:54:28 -0600
206 altos (0.5+77+gc57bd7f) unstable; urgency=low
208 * build for Debian from git
210 -- Bdale Garbee <bdale@gag.com> Mon, 12 Oct 2009 15:57:19 -0600