update changelogs for Debian build
[fw/altos] / debian / changelog
1 altos (0.6+95+g2f45953) unstable; urgency=low
2
3   * update changelogs for Debian build
4   * conditionalize use of git on executability of /usr/bin/git binary
5
6  -- Bdale Garbee <bdale@gag.com>  Wed, 24 Feb 2010 17:30:00 -0700
7
8 altos (0.6+88+gdeccc10) unstable; urgency=low
9
10   * add gawk as a build dependency since strtonum is a gawk extension
11
12  -- Bdale Garbee <bdale@gag.com>  Wed, 24 Feb 2010 16:44:35 -0700
13
14 altos (0.6+86+g2491282) unstable; urgency=low
15
16   [ Keith Packard ]
17   * Disable monitor mode before attempting radio test.
18   * Ensure that ao_alarm waits at least the specified time
19   * Remove dbg driver code from telemetrum/teledongle
20   * Add AT45DBxx1D driver
21   * Remove green LED and temp sensor from v0.2 code
22   * Add at45db161d.h header file for new flash part.
23   * Add 'f' command to display flash status register contents
24   * Dump more flash parameters for the flash_status command
25   * Dump config block from read/write config and flash_status commands
26   * Don't set ao_flash_setup_done until we're actually done.
27   * Remove flash debugging printfs
28   * Add simple gps dump command 'g'
29   * Force idle mode by shorting the SPI clock to ground at boot time.
30   * Switch to using internal cc1111 temperature sensor
31   * Missing ao_mutex_put in gps_dump
32   * Compute daytime using GPS as time base
33   * Pull in a bit more data for filtering the start of the boost
34   * Log GPS data on pad after boost detect.
35   * Change barometer conversion code to shrink conversion table
36   * Change altos build process to support per-product compile-time
37     changes
38   * Update .gitignore files
39   * Quiet make output.
40   * Add back stack size checking to altos linking phase
41   * Must install .map files for ao-load to work
42
43  -- Bdale Garbee <bdale@gag.com>  Wed, 24 Feb 2010 14:53:01 -0700
44
45 altos (0.6+60+g10d1bbc) unstable; urgency=low
46
47   [ Keith Packard ]
48   * Use ao_radio_get/ao_radio_put in packet code.
49
50  -- Bdale Garbee <bdale@gag.com>  Sat, 19 Dec 2009 13:53:32 -0700
51
52 altos (0.6+58+gbbb152c) unstable; urgency=low
53
54   [ Keith Packard ]
55   * Re-order config values. Change frequency to cal
56   * Allow radio calibration to be set from ao-load
57   * Add --cal to man page
58
59  -- Bdale Garbee <bdale@gag.com>  Sat, 19 Dec 2009 12:05:26 -0700
60
61 altos (0.6+53+gcd49847) unstable; urgency=low
62
63   [ Keith Packard ]
64   * Remove send_serial and serial_baud commands.
65   * Make ao_cmd_decimal produce both 32 and 16 bit values.
66   * Add radio calibration configuration.
67
68  -- Bdale Garbee <bdale@gag.com>  Sat, 05 Dec 2009 11:02:49 -0700
69
70 altos (0.6+49+g9a1d7dd) unstable; urgency=low
71
72   [ Keith Packard ]
73   * Change default callsign to "N0CALL"
74
75  -- Bdale Garbee <bdale@gag.com>  Fri, 04 Dec 2009 21:01:55 -0700
76
77 altos (0.6+47+g4053309) unstable; urgency=low
78
79   * fix absolute path in debian/dirs, add Suggests for slim-altusmetrum
80   * change home URL in control file to be the AltOS page
81
82  -- Bdale Garbee <bdale@gag.com>  Thu, 26 Nov 2009 11:15:47 -0700
83
84 altos (0.6+43+gd6ba07e) unstable; urgency=low
85
86   [ Keith Packard ]
87   * Decode HDOP data from skytraq GPS
88   * Document ao-postflight --gps and --kml options.
89   * Make ao-postflight create filenames using input filenames.
90   * Make TD print 0000-00-00 for invalid dates.
91   * Fix --plot arg handling. Add -all option.
92   * Convert telemetry file GPS satellite information in cc_log_read
93   * Don't crash if --plot isn't passed on ao-postflight command line
94   * ao-postflight: compute barometric alt for each GPS position
95   * ao-postflight: don't try to use missing gps sat data
96   * Automatically extract flight number for eeprom and telem filenames.
97
98  -- Bdale Garbee <bdale@gag.com>  Sun, 22 Nov 2009 10:18:26 -0700
99
100 altos (0.6+32+g87e6f3e) unstable; urgency=low
101
102   [ Bdale Garbee ]
103   * fix typo in comment
104
105   [ Keith Packard ]
106   * Reduce igniter firing time from 500ms to 50ms.
107   * Add GPS date/time output to ao-postflight.
108   * Eliminate SiRF state values from ao-view.
109
110  -- Bdale Garbee <bdale@gag.com>  Fri, 20 Nov 2009 13:18:06 -0700
111
112 altos (0.6+27+gb0d7e3f) unstable; urgency=low
113
114   [ Keith Packard ]
115   * Add two-point accelerometer calibration.
116   * Remove "l" command as ao-dumplong no longer uses it
117   * Remove "d" command
118   * Remove "f" command
119   * Reformat ADC values to show all 16 bits
120   * ao_flight_test was using accel value for pressure too
121   * Pass accel calibration over telemetry stream. Telemetry data format
122     change.
123   * Add ability to dump eeprom data over radio link.
124   * In packet master, move USB flush from packet thread to echo thread
125   * In USB pollchar, wait for packet before re-checking USB out len
126   * Explicitly use USB I/O routines in packet code
127   * Flush pending input when switching to remote packet mode
128   * Stop recording in ao-dumplog after receiving an invalid block
129   * Move ao_match_word from ao_ignite.c to ao_cmd.c
130   * Add Watchdog Timer Control register definitions
131   * Add reboot command.
132   * Return radio to telemetry settings when packet system closed.
133   * ao-postflight: fix sloppy gps sat data realloc code (was crashing).
134   * Loosen tolerances for main->landed transition
135   * Provide a dummy 'uninstall' target in the src directory.
136   * Share telemetry parsing code in cc library.
137   * Enable telemetry receive in ao_view
138   * Switch order of serial/flight in ao-postflight summary
139   * Add flight number to telemetry stream.
140   * Add date to GPS data, captured from GPRMC packet.
141   * Stop using SiRF state info.
142
143  -- Bdale Garbee <bdale@gag.com>  Fri, 20 Nov 2009 11:43:56 -0700
144
145 altos (0.6) unstable; urgency=low
146
147   [ Keith Packard ]
148   * Add support for the SkyTraq GPS unit
149   * Build two versions of TM, one for SiRF, one for SkyTraq
150   * Save some DSEG space by marking cmd functions __reentrant
151   * Add ao_wake_task and ao_exit
152   * Add keyhole-markup generation for ao-postflight.
153   * Initial packet bits. Just testing transmission
154   * Add radio carrier command
155   * Wait for TX to finish sending data
156   * Add ao_alarm
157   * Remove reason from ao_dma_abort
158   * Switch packet code from timer thread to ao_alarm
159   * Use ao_radio_done to wait for TX to completely finish with packet
160   * Send SYN packet to set sequence numbers
161   * Add RFIM register
162   * Do more flushing in packet test code
163   * Use ao_alarm for ao_delay so it can be easily interrupted
164   * Poke master to speed up packet rate when things are busy
165   * No need to wakeup &ao_tick_count now
166   * Enable packet-based communcation to command processor
167   * Add more docs to the README file
168   * Disable interrupts while removing tasks from task list
169   * Add ao_usb_pollchar to ao.h
170
171  -- Bdale Garbee <bdale@gag.com>  Mon, 02 Nov 2009 16:53:45 -0700
172
173 altos (0.5+90+g127c312) unstable; urgency=low
174
175   * de-version the libreadline-dev build dependency
176
177  -- Bdale Garbee <bdale@gag.com>  Mon, 02 Nov 2009 15:57:29 -0700
178
179 altos (0.5+86+g2de548f) unstable; urgency=low
180
181   * automate push of updated and tagged master branch during
182     debian/rules prebuild
183   * flush repetitive junk out of debian/changelog, and update the
184     prebuild target
185   * add support for tagging git repository on each Debian package build
186
187  -- Bdale Garbee <bdale@gag.com>  Mon, 12 Oct 2009 16:54:28 -0600
188
189 altos (0.5+77+gc57bd7f) unstable; urgency=low
190
191   * build for Debian from git
192
193  -- Bdale Garbee <bdale@gag.com>  Mon, 12 Oct 2009 15:57:19 -0600
194