From: Keith Packard Date: Fri, 23 Nov 2012 06:30:15 +0000 (-0800) Subject: Update MicroPeak page to match current feature set X-Git-Url: https://git.gag.com/?a=commitdiff_plain;h=c79f76e3cc869908453c4c43bfe8eae1b15053e2;p=web%2Faltusmetrum Update MicroPeak page to match current feature set Signed-off-by: Keith Packard --- diff --git a/MicroPeak/index.mdwn b/MicroPeak/index.mdwn index 647f21e..b6fecd3 100644 --- a/MicroPeak/index.mdwn +++ b/MicroPeak/index.mdwn @@ -9,9 +9,9 @@ rocketry altitude measurements. -Production units will be available from the -[Garbee and Garbee](http://auric.gag.com) web -store. +Production units are available from the +[Garbee and Garbee](http://auric.gag.com/index.php?route=product/product&product_id=80) +web store ## Documentation ## @@ -22,7 +22,7 @@ The MicroPeak manual is available in ## Hardware Features ## * Measure ground pressure and peak altitude pressure. - * Blue LED blinks out maximum height in decimeters. + * Orange LED blinks out maximum height in decimeters. * 18mm x 14mm. 1.9g including battery. * Power switch. @@ -59,14 +59,14 @@ Here's a close-up view of the hardware * High precision — 2.4Pa resolution (approximately 20cm at sea level) * Factory calibrated. * CR1025 Lithium Battery - * 30mAh. Runs MicroPeak for 10 hours on the pad or in flight + * 30mAh. Runs MicroPeak for more than 40 hours on the pad or in flight * Standard 6-pin AVR programming interface. * Software Features * Written in C * Samples pressure every 96ms * Delay 30s after power-on to finish airframe prep - * Detect boost with 10m altitude change + * Detect boost with 20m altitude change * Exponential averaging filter to minimize transient effects. * Tools Used