From: Tarek BOCHKATI Date: Wed, 12 Feb 2020 11:14:06 +0000 (+0100) Subject: tcl/board: update ST NUCLEO-H745ZI-Q configuration file to use dapdirect X-Git-Url: https://git.gag.com/?a=commitdiff_plain;ds=sidebyside;h=22df29eee8033be5dd9bdf2429701fa2252dd80b;p=fw%2Fopenocd tcl/board: update ST NUCLEO-H745ZI-Q configuration file to use dapdirect this board embeds and STLINK DAP capable firmware Change-Id: I276e9f44ad6cf7d1ff664898bbc884676bdbc967 Signed-off-by: Tarek BOCHKATI Reviewed-on: http://openocd.zylin.com/5316 Reviewed-by: Tomas Vanek Tested-by: jenkins Reviewed-by: Antonio Borneo --- diff --git a/tcl/board/st_nucleo_h745zi.cfg b/tcl/board/st_nucleo_h745zi.cfg index bb8a396b5..22d36f686 100644 --- a/tcl/board/st_nucleo_h745zi.cfg +++ b/tcl/board/st_nucleo_h745zi.cfg @@ -1,16 +1,14 @@ # This is an ST NUCLEO-H745ZI-Q board with single STM32H745ZITx chip. -source [find interface/stlink.cfg] -transport select hla_swd +source [find interface/stlink-dap.cfg] +transport select dapdirect_swd -# ST-Link HLA interface do not support multi-AP debugging -# then setting DUAL_CORE and USE_CTI has no effect, because -# it will fall back to single core configuration +# STM32H745xx devices are dual core (Cortex-M7 and Cortex-M4) set DUAL_CORE 1 + +# enable CTI for cross halting both cores set USE_CTI 1 source [find target/stm32h7x_dual_bank.cfg] -# when using ST-Link HLA adapter, DBGMCU accesses are done via AP0 -# unfortunately DBGMCU is not accessible when SRST is asserted reset_config srst_only