tcl/target: swm050: fix to allow to use with ST-Link

Currently the code assumes the adapter uses raw SWD, and the expected ID
code of the CPU is even wrong. An adapter speed is also not specified.
All these prevents the config file to be used with ST-Link.

Fix the config file, to allow it to be used with ST-Link.

Change-Id: I1244320fabfe8ee23da5a56a592dbeddc72cc8d5
Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
Reviewed-on: http://openocd.zylin.com/5297
Tested-by: jenkins
Reviewed-by: Caleb Szalacinski <contact@skiboy.net>
Reviewed-by: Tomas Vanek <vanekt@fbl.cz>

diff --git a/tcl/target/swm050.cfg b/tcl/target/swm050.cfg
index a819f9c426f19aa86bd0442c3d701068cb2874bc..2c4ab34fea59a5f33b4fcd20b79ffe68c066319c 100644 (file)
--- a/tcl/target/swm050.cfg
+++ b/tcl/target/swm050.cfg
@@ -1,5 +1,7 @@
 # Synwit SWM050
 
+source [find target/swj-dp.tcl]
+
 if { [info exists CHIPNAME] } {
        set _CHIPNAME $CHIPNAME
 } else {
@@ -16,10 +18,10 @@ if { [info exists WORKAREASIZE] } {
 if { [info exists CPUTAPID] } {
        set _CPUTAPID $CPUTAPID
 } else {
-       set _CPUTAPID 0x410CC200
+       set _CPUTAPID 0x0bb11477
 }
 
-swd newdap $_CHIPNAME cpu -expected-id $_CPUTAPID
+swj_newdap $_CHIPNAME cpu -expected-id $_CPUTAPID
 dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu
 set _TARGETNAME $_CHIPNAME.cpu
 target create $_TARGETNAME cortex_m -dap $_CHIPNAME.dap
@@ -27,6 +29,7 @@ $_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE
 set _FLASHNAME $_CHIPNAME.flash
 flash bank $_FLASHNAME swm050 0x0 0x2000 0 0 $_TARGETNAME
 
+adapter_khz 1000
 
 $_TARGETNAME configure -event reset-init {
        # Stop the watchdog, just to be safe