oshpark wants two holes, one at either end, with copper painted around
them on both sides. I've done this by making round-end pads that go
from hole to hole. When you use this package, make sure you paint a
19.68mil trace in the outline layer between the holes; I can't see any
way to get that into the package.
Signed-off-by: Keith Packard <keithp@keithp.com>
pin_mm(x - width / 2, y, drill, pin_copper, "mnt", "mnt");
pin_mm(x - width / 2, y, drill, pin_copper, "mnt", "mnt");
- if (drill <= width/2)
- pin_mm(x, y, drill, pin_copper, "mnt", "mnt");
+ pad_mm_options(x, y, width + pin_copper*2 + drill, drill + pin_copper * 2, "mnt", "mnt", "");
+ pad_mm_options(x, y, width + pin_copper*2 + drill, drill + pin_copper * 2, "mnt", "mnt", "onsolder");
pin_mm(x + width / 2, y, drill, pin_copper, "mnt", "mnt");
}
pin_mm(x + width / 2, y, drill, pin_copper, "mnt", "mnt");
}