X-Git-Url: https://git.gag.com/?a=blobdiff_plain;f=tcl%2Ftarget%2Faduc702x.cfg;h=c9037100fe7ce5da96118944fd7f7749c66da319;hb=ca52cfb2b34d684d10e9c91eeb2c6a66a1448b9f;hp=b60c9679bbe11a053e4bdca803e565fd0edfc253;hpb=6881c1b6d686c91a8cd604bdcd6098ab62d4dcb9;p=fw%2Fopenocd diff --git a/tcl/target/aduc702x.cfg b/tcl/target/aduc702x.cfg index b60c9679b..c9037100f 100644 --- a/tcl/target/aduc702x.cfg +++ b/tcl/target/aduc702x.cfg @@ -1,23 +1,25 @@ +# SPDX-License-Identifier: GPL-2.0-or-later + if { [info exists CHIPNAME] } { - set _CHIPNAME $CHIPNAME + set _CHIPNAME $CHIPNAME } else { - set _CHIPNAME aduc702x + set _CHIPNAME aduc702x } if { [info exists ENDIAN] } { - set _ENDIAN $ENDIAN + set _ENDIAN $ENDIAN } else { - # This config file was defaulting to big endian.. - set _ENDIAN little + # This config file was defaulting to big endian.. + set _ENDIAN little } if { [info exists CPUTAPID] } { - set _CPUTAPID $CPUTAPID + set _CPUTAPID $CPUTAPID } else { - set _CPUTAPID 0x3f0f0f0f + set _CPUTAPID 0x3f0f0f0f } -jtag_nsrst_delay 200 +adapter srst delay 200 jtag_ntrst_delay 200 ## JTAG scan chain @@ -35,7 +37,8 @@ $_TARGETNAME configure -work-area-phys 0x10000 -work-area-size 0x2000 ## flash configuration # only target number is needed -flash bank aduc702x 0 0 0 0 0 +set _FLASHNAME $_CHIPNAME.flash +flash bank $_FLASHNAME aduc702x 0 0 0 0 $_TARGETNAME ## If you use the watchdog, the following code makes sure that the board ## doesn't reboot when halted via JTAG. Yes, on the older generation @@ -44,9 +47,9 @@ flash bank aduc702x 0 0 0 0 0 proc watchdog_service {} { global watchdog_hdl mww 0xffff036c 0 -# puts "watchdog!!" +# echo "watchdog!!" set watchdog_hdl [after 500 watchdog_service] } $_TARGETNAME configure -event reset-halt-post { watchdog_service } -$_TARGETNAME configure -event old-pre_resume { global watchdog_hdl; after cancel $watchdog_hdl } +$_TARGETNAME configure -event resume-start { global watchdog_hdl; after cancel $watchdog_hdl }