X-Git-Url: https://git.gag.com/?a=blobdiff_plain;f=tcl%2Finterface%2Fraspberrypi2-native.cfg;h=547df0872f311af6c5e0374702cdff88c0756b72;hb=9ffeedb5794e5ebe7b3a7d7fd63fde4d7124c0dd;hp=26a31c55e0deca8d9b4198dfac0c6690c6f8c943;hpb=5a98ff786e11cec4c4ed4f53c69ab2d6de30eac9;p=fw%2Fopenocd

diff --git a/tcl/interface/raspberrypi2-native.cfg b/tcl/interface/raspberrypi2-native.cfg
index 26a31c55e..547df0872 100644
--- a/tcl/interface/raspberrypi2-native.cfg
+++ b/tcl/interface/raspberrypi2-native.cfg
@@ -1,3 +1,5 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
 #
 # Config for using Raspberry Pi's expansion header
 #
@@ -8,30 +10,30 @@
 # Do not forget the GND connection, pin 6 of the expansion header.
 #
 
-interface bcm2835gpio
+adapter driver bcm2835gpio
 
-bcm2835gpio_peripheral_base 0x3F000000
+bcm2835gpio peripheral_base 0x3F000000
 
 # Transition delay calculation: SPEED_COEFF/khz - SPEED_OFFSET
 # These depend on system clock, calibrated for stock 700MHz
-# bcm2835gpio_speed SPEED_COEFF SPEED_OFFSET
-bcm2835gpio_speed_coeffs 146203 36
+# bcm2835gpio speed SPEED_COEFF SPEED_OFFSET
+bcm2835gpio speed_coeffs 146203 36
 
 # Each of the JTAG lines need a gpio number set: tck tms tdi tdo
 # Header pin numbers: 23 22 19 21
-bcm2835gpio_jtag_nums 11 25 10 9
+bcm2835gpio jtag_nums 11 25 10 9
 
 # Each of the SWD lines need a gpio number set: swclk swdio
 # Header pin numbers: 23 22
-bcm2835gpio_swd_nums 11 25
+bcm2835gpio swd_nums 11 25
 
 # If you define trst or srst, use appropriate reset_config
 # Header pin numbers: TRST - 26, SRST - 18
 
-# bcm2835gpio_trst_num 7
+# bcm2835gpio trst_num 7
 # reset_config trst_only
 
-# bcm2835gpio_srst_num 24
+# bcm2835gpio srst_num 24
 # reset_config srst_only srst_push_pull
 
 # or if you have both connected,