X-Git-Url: https://git.gag.com/?a=blobdiff_plain;f=tcl%2Finterface%2Fraspberrypi-native.cfg;h=02a35635006063561ead1f12dd9d944c07d530a3;hb=0dd969d83badb6793519ee99dd8ab8579d5f59df;hp=2d0547f310d1b70f3f2b3949d77cffa6df3d70ec;hpb=2aa2ed1d8a3c489b0b7c1590e91f9989f2c42fb6;p=fw%2Fopenocd

diff --git a/tcl/interface/raspberrypi-native.cfg b/tcl/interface/raspberrypi-native.cfg
index 2d0547f31..02a356350 100644
--- a/tcl/interface/raspberrypi-native.cfg
+++ b/tcl/interface/raspberrypi-native.cfg
@@ -1,3 +1,5 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
 #
 # Config for using Raspberry Pi's expansion header
 #
@@ -10,28 +12,32 @@
 
 adapter driver bcm2835gpio
 
-bcm2835gpio_peripheral_base 0x20000000
+bcm2835gpio peripheral_base 0x20000000
 
 # Transition delay calculation: SPEED_COEFF/khz - SPEED_OFFSET
 # These depend on system clock, calibrated for stock 700MHz
-# bcm2835gpio_speed SPEED_COEFF SPEED_OFFSET
-bcm2835gpio_speed_coeffs 113714 28
+# bcm2835gpio speed SPEED_COEFF SPEED_OFFSET
+bcm2835gpio speed_coeffs 113714 28
 
 # Each of the JTAG lines need a gpio number set: tck tms tdi tdo
 # Header pin numbers: 23 22 19 21
-bcm2835gpio_jtag_nums 11 25 10 9
+adapter gpio tck -chip 0 11
+adapter gpio tms -chip 0 25
+adapter gpio tdi -chip 0 10
+adapter gpio tdo -chip 0 9
 
 # Each of the SWD lines need a gpio number set: swclk swdio
 # Header pin numbers: 23 22
-bcm2835gpio_swd_nums 11 25
+adapter gpio swclk -chip 0 11
+adapter gpio swdio -chip 0 25
 
 # If you define trst or srst, use appropriate reset_config
 # Header pin numbers: TRST - 26, SRST - 18
 
-# bcm2835gpio_trst_num 7
+# adapter gpio trst -chip 0 7
 # reset_config trst_only
 
-# bcm2835gpio_srst_num 24
+# adapter gpio srst -chip 0 24
 # reset_config srst_only srst_push_pull
 
 # or if you have both connected,