X-Git-Url: https://git.gag.com/?a=blobdiff_plain;f=tcl%2Fboard%2Frsc-w910.cfg;h=b07f9405f7798f3e3fc6969bf94ae74ba51a58cb;hb=4157732bd84c4e9e4b55357e1dc9a96078a35ee1;hp=636a05399d0e7ccaba93993620bfb5ca51aa07dc;hpb=30da7c67cec8b315972377b5389735ff11f6042c;p=fw%2Fopenocd

diff --git a/tcl/board/rsc-w910.cfg b/tcl/board/rsc-w910.cfg
index 636a05399..b07f9405f 100644
--- a/tcl/board/rsc-w910.cfg
+++ b/tcl/board/rsc-w910.cfg
@@ -1,3 +1,5 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
 # Avalue RSC-W8910 sbc
 # http://www.avalue.com.tw/products/RSC-W910.cfm
 # 2MB NOR Flash
@@ -12,8 +14,8 @@ source [find target/nuc910.cfg]
 #
 reset_config trst_and_srst srst_pulls_trst
 
-adapter_khz 1000
-adapter_nsrst_delay 100
+adapter speed 1000
+adapter srst delay 100
 jtag_ntrst_delay 100
 
 $_TARGETNAME configure -work-area-phys 0x00000000 -work-area-size 0x04000000 -work-area-backup 0
@@ -28,12 +30,12 @@ nand device $_NANDNAME nuc910 $_TARGETNAME
 # Target events
 #
 
-$_TARGETNAME configure -event reset-start {adapter_khz 1000}
+$_TARGETNAME configure -event reset-start {adapter speed 1000}
 
 $_TARGETNAME configure -event reset-init {
 	# switch on PLL for 200MHz operation
 	# running from 15MHz input clock
-	
+
 	mww 0xB0000200 0x00000030 ;# CLKEN
 	mww 0xB0000204 0x00000f3c ;# CLKSEL
 	mww 0xB0000208 0x05007000 ;# CLKDIV
@@ -41,17 +43,17 @@ $_TARGETNAME configure -event reset-init {
 	mww 0xB0000210 0x00002b63 ;# PLLCON1
 	mww 0xB000000C 0x08817fa6 ;# MFSEL
 	sleep 10
-	
+
 	# we are now running @ 200MHz
 	# enable all openocd speed tweaks
-	
+
 	arm7_9 dcc_downloads enable
 	arm7_9 fast_memory_access enable
-	adapter_khz 15000
-	
+	adapter speed 15000
+
 	# map nor flash to 0x20000000
 	# map sdram to 0x00000000
-	
+
 	mww 0xb0001000 0x000530c1 ;# EBICON
 	mww 0xb0001004 0x40030084 ;# ROMCON
 	mww 0xb0001008 0x000010ee ;# SDCONF0