X-Git-Url: https://git.gag.com/?a=blobdiff_plain;f=tcl%2Fboard%2Fglyn_tonga2.cfg;h=31aa9ff5ea9b4976a6b8c19d0ab9b925791af97b;hb=b304971f380d89d5e934859b2c36e81c26df6eee;hp=17ed3cf20b1f8e6451b3b81cccfc6b410411a226;hpb=b6068f5a48f26db419217ac6b407a2746759e62a;p=fw%2Fopenocd

diff --git a/tcl/board/glyn_tonga2.cfg b/tcl/board/glyn_tonga2.cfg
index 17ed3cf20..31aa9ff5e 100644
--- a/tcl/board/glyn_tonga2.cfg
+++ b/tcl/board/glyn_tonga2.cfg
@@ -19,12 +19,12 @@ source [find target/tmpa900.cfg]
 # Initial JTAG speed should not exceed 1/6 of the initial CPU clock
 # frequency (24MHz). Be conservative and use 1/8 of the frequency.
 # (24MHz / 8 = 3MHz)
-adapter_khz 3000
+adapter speed 3000
 
 $_TARGETNAME configure -event reset-start {
 	# Upon reset, set the JTAG frequency to 3MHz again, see above.
 	echo "Setting JTAG speed to 3MHz until clocks are initialized."
-	adapter_khz 3000
+	adapter speed 3000
 
 	# Halt the CPU.
 	halt
@@ -41,7 +41,7 @@ $_TARGETNAME configure -event reset-init {
 	# Tests showed that 15MHz works OK, higher speeds can cause problems,
 	# though. Not sure if this is a CPU issue or JTAG adapter issue.
 	echo "Increasing JTAG speed to 15MHz."
-	adapter_khz 15000
+	adapter speed 15000
 
 	# Enable faster memory access.
 	arm7_9 fast_memory_access enable